Lighting and visibility
temporarily (“headlamp flash”) by pulling up the
stalk.
Front foglamps / Rear
Exterior lighting control
stalk
4
foglamp
Switching on the lamps after
switching off the ignition
To reactivate the lighting control, rotate the
ring to the "0" position - lamps off, then to
the desired position.
(Depending on version)
They operate with the sidelamps, dipped
or main beam headlamps on.
Main lighting
If the driver's door is opened, a temporary
audible signal warns the driver that the
lamps are on.
In some weather conditions (e.g. low
temperature or humidity), the
presence of misting on the internal surface
of the glass of the headlamps and rear lamps
is normal; it disappears after the lamps have
been on for a few minutes.
►ꢀ Turn the ring to align the symbol with the
marking.
Switching on the foglamps is
prohibited in clear weather or in rain,
both day and night. In these situations, the
power of their beams may dazzle other
drivers. They must only be used in fog or
falling snow (rules may vary depending on
country).
Lighting off (ignition off)
Sidelamps only
Dipped or main beam headlamps
Front foglamps
(Depending on version)
They only work if the sidelamps or
dipped beam headlamps are on.
Do not forget to switch off the foglamps
when they are no longer necessary.
Headlamp dipping
►ꢀ Turn and align the selection ring to switch
between dipped and main beam headlamps.
In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
►ꢀ Turn the ring to align the symbol with the
marking.
25
English 
