Lighting and visibility
Do not operate the wipers on a dry
windscreen. Under extremely hot or
cold conditions, ensure that the wiper blades
are not stuck to the windscreen before
operating the wipers.
Intermittent wiping
Front screenwash
4
►ꢀ Pull the wiper control stalk towards you and
hold.
The screenwash and windscreen wipers operate
for as long as the control stalk is pulled.
Termination of the screenwash is followed by a
final wiping cycle.
Changing a wiper blade
Before removing a front wiper
Windscreen wipers
To avoid damaging the wiper blades,
do not operate the screenwash if the
screenwash reservoir is empty.
Only operate the screenwash if there is no
risk of the fluid freezing on the windscreen
and hindering visibility. During the winter
period, use "very cold climate" rated
products.
►ꢀ Within one minute after switching off the
ignition, operate the wiper stalk to position the
wiper blades vertically on the windscreen.
or
►ꢀ A minute after switching off the ignition,
straighten the arms manually.
Never top up with water.
►ꢀ To select the wiping speed: raise or lower
the stalk to the desired position.
Single wiping / Mist
Rear wiper
(Depending on version)
Removing
►ꢀ Lift the corresponding wiper arm.
Off
►ꢀ Unclip the wiper blade and remove it.
Intermittent wiping
Slow wiping
Fast wiping
Refitting
►ꢀ Position and clip the new wiper blade to the
arm.
►ꢀ Fold down the wiper arm carefully.
►ꢀ Turn the ring to align the desired symbol
with the marking.
Screenwash-wipe
After refitting a front wiper
Single wipe
►ꢀ Pull the stalk briefly towards you.
►ꢀ Switch on the ignition.
Off
27
English 