Practical information
Battery
Access to the battery
Starting using another
battery
The presence of this label, in particular
with the Stop & Start system, indicates
the use of a 12 V lead-acid battery with
special technology and specification;
the involvement of a CITROËN dealer
or a qualified workshop is essential
when replacing or disconnecting the
battery.
Failure to observe this recommendation
may cause premature wear of the
battery.
The battery is located under the bonnet.
To gain access to it:
Connect the red cable to the positive
terminal (+) of the flat battery A, then to the
positive terminal (+) of the slave battery B.
Connect one end of the green or black
cable to the negative terminal (-) of the
slave battery B
Connect the other end of the green or black
cable to the remote negative terminal (-) of
your vehicle
open the bonnet using the interior release
lever, then the exterior safety catch,
secure the bonnet stay,
lift the plastic cover on the (+) terminal.
After refitting the battery by a CITROËN
dealer or a qualified workshop, the Stop
& Start system will only be active after
a continuous period of immobilisation of
the vehicle, a period which depends on
the climatic conditions and the state of
charge of the battery (up to about
8 hours).
Start the slave vehicle.
Operate the starter of the broken down
vehicle and let the engine run.
Wait until the engine returns to idle and
disconnect the cables.
11
179
English 