Advertisement

Advertisement

In the event of a breakdown -> 12 V battery for Your Citroen C3 SUV Third Generation (2016-2024)

In the event of a breakdown  
Table of fuses  
Fuse  
N°  
Rating  
(A)  
Functions  
F1  
40  
20  
10  
10  
40  
40  
Air conditioning.  
F16  
F18  
F19  
F25  
F29  
Front foglamp.  
Right-hand main beam headlamp.  
Left-hand main beam headlamp.  
Trailer attachment pre-equipment.  
Windscreen wipers.  
circumstances, be discarded with household  
waste.  
Take used remote control batteries and  
vehicle batteries to a special collection point.  
General points  
12 V battery  
Procedure for starting the engine using another  
battery or charging a discharged battery.  
Lead-acid starter batteries  
Batteries contain harmful substances  
such as sulphuric acid and lead.  
They must be disposed of in accordance  
with regulations and must not, in any  
Protect your eyes and face before  
handling the battery.  
All operations on the battery must be carried  
out in a well ventilated area and away from  
128  
In the event of a breakdown  
naked flames and sources of sparks, so as to  
avoid the risk of explosion or fire.  
Wash your hands afterwards.  
Never start the engine by connecting a  
battery charger.  
► Lift the plastic cover on the (+) terminal, if the  
vehicle has one.  
► Connect the red cable to the (+) terminal of  
flat battery A (at the metal elbow), then to the  
(+) terminal of the backup battery B or of the  
booster.  
► Connect one end of the green or black cable  
to the (-) terminal of the backup battery B or of  
the booster (or to an earth point on the assisting  
vehicle).  
► Connect the other end of the green or black  
cable to the earth point C.  
8
Never use a 24 V or higher battery booster.  
Check beforehand that the backup battery  
has a nominal voltage of 12 V and a capacity  
at least equal to that of the discharged  
battery.  
The two vehicles must not be in contact with  
each other.  
Switch off all electricity-consuming equipment  
on both vehicles (audio system, wipers,  
lighting, etc.).  
Accessing the battery  
The battery is located under the bonnet.  
Make sure that the jump leads are well away  
from the engine’s moving parts (fan, belt,  
etc.).  
Do not disconnect the (+) terminal while the  
engine is running.  
► Start the engine on the assisting vehicle and  
leave it running for a few minutes.  
► Operate the starter on the broken down  
vehicle and let the engine run.  
If the engine does not start immediately, switch  
off the ignition and wait a few moments before  
trying again.  
For access to the (+) terminal:  
► Release the bonnet by pulling the internal  
release lever, then the external safety catch.  
► Raise the bonnet.  
(+) Positive terminal.  
This terminal has a quick-release clamp.  
(-) Negative terminal.  
As the battery's negative terminal is not  
accessible, a remote earth point is placed on the  
structure of the front right wing.  
► Wait for it to return to idle.  
► Disconnect the jump leads in reverse order.  
► Refit the plastic cover to the (+) terminal, if  
the vehicle has one.  
► Allow the engine to run for at least  
30 minutes, with the vehicle stationary, so that  
the battery reaches an adequate state of charge.  
Starting using another  
battery  
If the vehicle's battery is flat, the engine can be  
started using a backup battery (either external or  
from another vehicle) and jump leads or using a  
battery booster.  
Driving immediately without having  
reached a sufficient level of charge may  
affect some of the vehicle's functionalities.  
129  
In the event of a breakdown  
Some functions, including Stop & Start,  
are not available if the battery is not  
sufficiently charged.  
► Switch off charger B before connecting  
the cables to the battery, so as to avoid any  
dangerous sparks.  
container has not cracked, which would mean  
a risk of toxic and corrosive acid leaking.  
► Ensure that the charger cables are in good  
condition.  
► Lift the plastic cover on the (+) terminal, if the  
vehicle has one.  
► Connect the cables of charger B as follows:  
• the positive (+) red cable to the (+) terminal  
of battery A,  
• the negative (-) black cable to earth point C  
on the vehicle.  
Disconnecting the battery  
Charging the battery using a  
battery charger  
For optimum service life of the battery, it is  
essential to maintain an adequate state of  
charge.  
In some circumstances, it may be necessary to  
charge the battery:  
– using the vehicle mainly for short journeys;  
– if the vehicle is to be taken off the road for  
several weeks.  
In order to maintain an adequate state of charge  
for starting the engine, it is recommended that  
the battery be disconnected if the vehicle is  
taken out of service for a long period.  
Before disconnecting the battery:  
► close all openings (doors, boot, windows),  
► switch off all electrical consumers (audio  
system, wipers, lighting, etc.),  
► switch off the ignition and wait for four  
minutes.  
► At the end of the charging operation, switch  
off charger B before disconnecting the cables  
from battery A.  
At the battery, it is only necessary to disconnect  
the (+) terminal.  
Contact a CITROËN dealer or a qualified  
workshop.  
If this label is present, use only a 12 V  
charger to avoid causing irreversible  
damage to the electrical components  
connected to the Stop & Start system.  
Quick-release terminal clamp  
Disconnecting the (+) terminal  
To charge the vehicle's battery yourself,  
use only a charger compatible with  
lead-acid batteries with a nominal voltage of  
12 V.  
24V  
+
Follow the instructions provided by the  
manufacturer of the charger.  
12V  
Never reverse polarities.  
Never try to charge a frozen battery - risk  
of explosion!  
It is not necessary to disconnect the  
battery.  
If the battery has frozen, have it checked by a  
CITROËN dealer or by a qualified workshop  
who will check that the internal components  
have not been damaged and that the  
► Switch off the ignition.  
► Switch off all electrical consumers (audio  
system, lighting, wipers, etc.).  
► Raise the lever A fully to release the clamp  
B.  
130