Access
Central locking not
functioning
2
Use these procedures in the following cases:
– Central locking malfunction.
– Battery disconnected or discharged
Warning
In the event of a malfunction of the
central locking system, the battery must be
disconnected to ensure that the vehicle is
locked fully.
► Insert the key into the door lock
► Turn the key towards the front/rear to
unlock/lock the vehicle
Driver's door
► Turn towards the rear again within 5
Turn the key anticlockwise to lock it, or
clockwise to unlock it.
All doors
Use the manual knob in the driver's door to lock
in the four doors and close the doors.
seconds to deadlock the vehicle.
1. Insert the mechanical key (incorporated
into the remote control) into the lock to
open the vehicle
Tip
If vehicle is fitted with an alarm, it will
not be activated when locking with the key.
If the alarm is activated, the siren sounds
when the door is opened; switch on the
ignition to stop it.
2. Please keep the electronic key against
the back-up Immo-Antenna inside the cup-
holder
Changing the remote
control battery
3. Start the vehicle
3 Steps to follow for keyless entry & start
Keyless entry - Specific
recommendations
Battery ref.: CR2032/3 Volts.
(Applicable for keyless entry and start)
1. Key should not be kept on the Mobile
wireless charging area. Wireless charging
coil may impact the performance.
2. Should not leave any one of the key inside
the vehicle and vehicle will not auto lock as
one key is present in the vehicle 3.
3. Key should be inside the vehicle to crank
the vehicle. Vehicle seeks for key while
trying to crank the engine using Start Stop
Button and during vehicle speed variation
(High to Low).
23
English 