Advertisement

Advertisement

Lighting and visibility -> Wiper control stalk for Your Citroen C4 Cactus SUV First Generation (2014-2018)

Lighting and visibility  
1. Driver + front passenger + rear  
Switching off  
passengers + load in the boot.  
The system does not operate:  
-. Driver + front passenger + rear  
-
below a certain angle of rotation of the  
steering wheel,  
above 25 mph (40 km/h),  
passengers + load in the boot.  
2. Driver only + maximum authorised load in  
-
-
the boot.  
when reverse gear is engaged.  
The initial setting is position 0.  
Activation/Deactivation  
The system is activated or deactivated via the  
vehicle configuration menu.  
Without cornering lighting  
4
F
In the Driving/Vehicle menu  
of the touch screen, select the  
"Vehicle settings" tab then  
"Headlamps" and activate/  
deactivate "Directional  
headlamps".  
Cornering lighting  
Wiper control stalk  
With cornering lighting  
If your vehicle is so equipped, this system  
makes use of the beam from a front foglamp  
to illuminate the inside of a bend, when the  
main or dipped beam headlamps are on and  
the vehicle speed is below 25 mph (40 km/h)  
(urban driving, winding road, intersections,  
parking manoeuvres, etc.).  
In wintry conditions, remove snow, ice or  
frost present on the windscreen, around  
the wiper arms and blades and the  
windscreen seal, before operating the  
wipers.  
Switching on  
This system starts:  
-
when the corresponding direction indicator  
is switched on,  
or  
-
from a certain angle of rotation of the  
steering wheel.  
65  
Lighting and visibility  
Rear wiper selection ring:  
Off.  
Windscreen wipers  
Do not operate the wipers on a dry  
windscreen. Under extremely hot or cold  
conditions, ensure that the wiper blades  
are not stuck to the windscreen before  
operating the wipers.  
Raise or lower the control to the desired  
position to change the wiping speed.  
Intermittent wiping.  
Fast wiping (heavy rain).  
Wash-wipe (set duration).  
Normal wiping (moderate rain).  
Manual controls  
The wipers are controlled directly by the driver.  
Intermittent wiping (proportional to  
the speed of the vehicle).  
Reverse gear  
When reverse gear is engaged, the rear wiper  
will come into operation automatically if the  
windscreen wipers are operating.  
Off.  
With manual wiping  
The system is activated or deactivated via the  
vehicle configuration menu.  
Single wipe (press downwards or  
pull the stalk briefly towards you,  
then release).  
This system is activated by default.  
or  
Automatic wiping (press down,  
then release) or single wipe (pull  
the stalk briefly towards you).  
If a significant accumulation of snow or ice  
is present, or when using a bicycle carrier  
on the boot, deactivate the automatic rear  
wiper.  
With AUTO wiping  
F
In the Driving/Vehicle menu  
of the touch screen, select  
the "Vehicle settings" tab  
then "Parking" and activate/  
deactivate "Rear wiper in  
reverse".  
Rear wiper  
66  
Lighting and visibility  
This position permits release of the windscreen  
wiper blades.  
It is used for cleaning or replacing the wiper  
blades. It can also be useful, in winter, to  
release the wiper blades from the windscreen.  
Front screenwash  
To avoid damaging the wiper blades,  
do not operate the screenwash if the  
screenwash reservoir is empty.  
Only operate the screenwash if there  
is no risk of the fluid freezing on the  
windscreen and hindering visibility. Always  
use screenwash fluid suitable for low  
temperatures during the winter period.  
F Operate the wiper stalk within one minute  
after switching off the ignition to position the  
wiper blades vertically on the windscreen.  
F To park the wiper blades again, switch on  
the ignition and operate the wiper stalk.  
Special position of the  
windscreen wipers  
4
To maintain the effectiveness of the wiper  
blades, it is advisable to:  
Pull the wiper control stalk towards you.  
The screenwash and windscreen wiper operate  
for as long as the control stalk is pulled.  
Stopping the screenwash is followed by a final  
wiping cycle.  
-
-
handle them with care,  
clean them regularly using soapy  
water,  
-
-
avoid using them to retain cardboard  
on the windscreen,  
replace them at the first signs of wear.  
Your vehicle is fitted with an innovative  
front screenwash system.  
The screenwash fluid is sprayed all along  
the length of the wiper blade, so avoiding  
impairment of the driver's view or that of  
the passengers.  
67