Advertisement

Advertisement

Access -> Boot for Your Citroen C4 Cactus SUV Second Generation (2018-2024)

Access  
► Immediately press the closed padlock button  
for a few seconds.  
► Switch off the ignition and remove the key  
from the switch.  
If the fault persists after reinitialisation, contact a  
CITROËN dealer or a qualified workshop without  
delay.  
Boot  
2
Opening  
The remote control is now fully operational  
again.  
Doors  
With Keyless Entry and Starting  
Opening  
From outside  
► After unlocking the vehicle or with the  
Keyless Entry and Starting electronic key in the  
recognition zone, pull the door handle.  
From inside  
► Pull the interior opening control of a door; this  
► With the vehicle unlocked or with the  
unlocks the vehicle completely.  
Keyless Entry and Starting electronic key in the  
recognition zone, press the centre of the tailgate  
opening control.  
The interior opening control on a rear  
door does not work if the child lock is on.  
For more information on the Child Lock, refer  
to the corresponding section.  
► Insert the mechanical key (incorporated into  
the remote control) into the lock to open the  
vehicle.  
► Lift the tailgate.  
For more information on the Remote control or  
on the Keyless Entry and Starting, please refer  
to the corresponding section.  
► Place the electronic key against the back-up  
reader under the parking brake lever and hold it  
there until the ignition is switched on.  
► Switch on the ignition by pressing the  
"START/STOP" button.  
With a manual gearbox, place the gear lever  
in neutral then fully depress the clutch pedal.  
With an automatic gearbox, while in mode  
P, depress the brake pedal.  
Closing  
If there is a fault or if it is difficult to move  
the tailgate when opening or closing it,  
have it checked as soon as possible by a  
CITROËN dealer or a qualified workshop to  
prevent the problem becoming worse, and  
potentially causing the tailgate to drop and  
thereby inflicting serious injuries.  
When a door is not closed correctly:  
with the engine running or the vehicle  
moving (speed below 6 mph (10 km/h)), a  
message appears in the screen.  
with the vehicle moving (speed above 6  
mph (10 km/h)), a message appears in the  
screen, accompanied by an audible signal.  
23  
Access  
System which protects and provides a deterrent  
against theft and break-ins.  
Closing  
Exterior perimeter monitoring  
The system checks for opening of the vehicle.  
The alarm is triggered if anyone tries to open a  
door, the boot or the bonnet, for example.  
Self-protection function  
► Insert a small screwdriver into hole A of the  
lock to unlock the boot.  
► Move the latch to the left.  
The system checks for the putting out of service  
of its components.  
The alarm is triggered if the battery, the central  
control or the siren wiring is put out of service or  
damaged.  
Locking after closing  
If the fault persists after closing again, the boot  
will remain locked.  
► Lower the tailgate using the interior grab  
handle.  
If the tailgate is not fully closed:  
For all work on the alarm system, contact  
a CITROËN dealer or a qualified  
workshop.  
In the event of a fault with the central  
locking system, it is essential to  
with the engine running or the vehicle  
moving (speed below 6 mph (10 km/h)), a  
message appears in the screen.  
with the vehicle moving (speed above 6  
mph (10 km/h)), a message appears in the  
screen, accompanied by an audible signal.  
disconnect the battery to lock the boot and so  
ensure complete locking of the vehicle.  
Locking the vehicle with full  
alarm system  
Alarm  
(Depending on version)  
Activation  
Back-up release  
To manually unlock the boot in the event of a  
battery or central locking failure.  
► Switch off the ignition and exit the vehicle.  
► Lock or deadlock the vehicle using the  
remote control or with the “Keyless Entry and  
Starting” system.  
Unlocking  
► Fold the rear seats to gain access to the lock  
from inside the boot.  
When the monitoring system is active, the red  
indicator lamp in the button flashes once per  
second and the direction indicators come on for  
about 2 seconds.  
The exterior perimeter monitoring is activated  
after 5 seconds.  
24