Advertisement

Advertisement

Instruments and Controls -> Service indicator for Your Citroen C4 Grand Picasso SUV First Generation (2006-2013)

I N S T R U M E N T S a n d C O N T R O L S  
5 seconds after the ignition is switched  
on, the spanner is switched off; the  
distance recorder resumes its normal  
operation. The display then indicates  
the total and trip distances.  
Service overdue  
Service indicator  
I
For 5 seconds after the ignition is  
switched on, the spanner flashes  
to indicate that the service must be  
carried out as soon as possible.  
Example: the service is overdue by  
300 miles/km.  
System which informs the driver  
when the next service is due, in ac-  
cordance with the manufacturer's  
servicing schedule.  
The point at which the service is  
due is calculated from the last indi-  
cator zero reset. It is determined by  
two parameters:  
For 5 seconds after the ignition is  
switched on, the display indicates:  
-
-
the distance travelled,  
the time elapsed since the last  
service.  
Less than 620 miles (1 000 km)  
remain before the next service is  
due  
Examples: 400 miles (900 km) re-  
main before the next service is due.  
More than 620 miles (1 000 km)  
remain before the next service  
is due  
For 5 seconds after the ignition is  
switched on, the spanner symbol-  
ising the service operations comes  
on. The distance recorder display  
line indicates the distance remaining  
before the next service is due.  
For 5 seconds after the ignition is  
switched on, the display indicates:  
5 seconds after the ignition is  
switched on, the distance recorder  
resumes its normal operation. The  
spanner remains lit.  
Example: 4 800 miles/km remain  
before the next service is due.  
For 5 seconds after the ignition is  
switched on, the display indicates:  
5 seconds after the ignition is  
switched on, the distance recorder  
resumes its normal operation. The  
spanner remains on to indicate that  
a service must be carried out soon.  
The distance remaining may be  
weighted by the time factor, depend-  
ing on the driver's driving habits.  
Therefore, the spanner may also  
come on if you have exceeded the  
two year service interval.  
t CITROEN compiled by C4owners.org  
31  
I N S T R U M E N T S a n d C O N T R O L S  
Service indicator zero reset  
Oil level gauge fault  
Engine oil level indicator  
I
System which informs the driver  
whether the engine oil level is cor-  
rect or not.  
This information is displayed for a  
few seconds when the ignition is  
switched on, after the service infor-  
mation.  
This is indicated by the flashing of  
"OIL --". Contact a CITROËN dealer.  
The level read will only be correct if  
the vehicle is on level ground and  
the engine has been off for more  
than 15 minutes.  
After each service, the service indi-  
cator must be reset to zero.  
The procedure for resetting to zero  
is as follows:  
switch off the ignition,  
press and hold the trip distance  
recorder zero reset button,  
switch on the ignition; the distance  
recorder display begins a count-  
down,  
Dipstick  
Refer to the "Checks" section to lo-  
cate the dipstick and the oil filler cap  
on your engine.  
Oil level correct  
Oil level low  
There are 2 marks on  
the dipstick:  
-
A = max; never ex-  
ceed this level,  
when the display indicates "=0",  
release the button; the spanner  
disappears.  
-
B = min; top up the  
level via the oil filler  
cap, using the type  
of oil suited to your  
engine.  
This is indicated by the flashing of  
"OIL", accompanied by an audible  
signal and a message on the multi-  
function screen.  
If the low oil level is confirmed by a  
check using the dipstick, it is essential  
that the level is topped up to prevent  
damage to the engine.  
Following this operation, if you wish  
to disconnect the battery, lock the  
vehicle and wait at least five minutes  
for the zero reset to be taken into ac-  
count.  
Copyright CITROEN compiled by C4owners.org  
32