VALUES FOR CHECKING AND ADJUSTING AXLE GEOMETRIES
IMPERATIVE: Respect the safety and cleanliness requirements.
Conditions for checking and adjusting.
Check the tyre pressures.
Tools.
Place the vehicle on a 4 column lift.
Check and adjust if necessary the vehicle heights (see corresponding
operation).
[1] Gauge for measuring radius of wheels (5 bolts) : 9801-T
[2] Gauge for height under bodyshell
: 2305-T
Steering rack locked at its zero point (see corresponding operation).
Switch off the ignition before removing the tools from the wheels.
Lower the vehicle.
WARNING: «Check and adjust the axle geometries at reference
height».
Start the engine.
Put the vehicle in the high position.
Put the vehicle in the normal height position (driving height).
Stop the engine.
Switch on the ignition.
Check and adjust the front and rear axle geometries at reference
height.
WARNING: Do not switch off the ignition during checking and
adusting of the front and rear axle geometries.
NOTE: Front of vehicle (following the arrow).
NOTE
A < B = Positive figure:
A > B = Negative figure:
+ =
- =
TOE-IN
B3CP02UC
TOE-OUT
129
English 