DE-PRESSURISING THE HYDRAULIC SUSPENSION CIRCUIT
Tools.
Go into the menu:
- Suspension.
- De-pressurisation.
[1] PROXIA station
[2] LEXIA station
: 4165-T
: 4171-T
Follow the instructions displayed on the screen.
Wait for the vehicle's suspension to sink completely.
NOTE: This operation takes around 3 minutes.
Switch off the ignition.
De-pressurisation.
NOTE: It is possible to de-pressurise the suspension by individual axle.
Disconnect the battery.
Using a diagnostic tool.
Without a diagnostic tool.
Start the engine.
Place the height control in the «LOW» position.
Wait for the vehicle height to reach the position required.
Stop the engine.
Connect the diagnostic tool [1] or [2] to the vehicle's diagnostic socket.
Switch on the ignition.
IMPERATIVE: Any LDS fluid that is collected must not be re-used.
NOTE: Collect the LDS fluid in order to keep the work area clean.
Respect the environment.
Start the engine.
Place the height control in the «LOW» position.
Stop the engine.
Carry out a global test.
201
English 