Instruments and controls
Dipstick
Zero re-set
Engine oil level indicator
A = maximum, never exceed
this level as a surplus of oil may
damage the engine.
Your CITROËN dealer or a qualified
workshop carries out this operation after
each service.
Depending on your vehicle's engine, when
the ignition is switched on, the engine oil
level is indicated for a few seconds, after the
service information.
Contact a CITROËN dealer or a
qualified workshop without delay.
However, if you carry out the service
yourself, the re-set procedure is as follows:
Oil level correct
B = minimum, top up the level via
the oil filler cap, using the grade
of oil suited to your engine.
-
-
switch off the ignition,
press and hold the trip recorder reset
button,
Low oil level
-
switch on the ignition.
Flashing of "OIL", linked
with the service warning
lamp, accompanied by
The display begins a countdown.
Trip recorder zero reset
button
an audible signal and a message in the
screen, indicates a low oil level which could
damage the engine.
With the ignition on, press the
button until the zeros appear.
If the low oil level is confirmed by a check
using the dipstick, it is essential that the
level is topped up.
When the display shows "=0", release
the button; the spanner disappears.
After this operation, if you wish to disconnect
the battery, lock the vehicle and wait for at
least five minutes, otherwise the zero re-set
will not be registered.
Lighting dimmer
Oil level gauge fault
With the lighting on, press the
button to vary the brightness
of the instruments and
Flashing of "OIL--"
indicates a malfunction
of the engine oil level
controls. When the lighting
indicator. Contact a CITROËN dealer or a
qualified workshop.
reaches the minimum (or maximum) setting,
release the button then press it again to
increase (or reduce) the brightness.
The level read will only be correct if
the vehicle is on level ground and the
engine has been off for more than
30 minutes.
As soon as the lighting is of the required
brightness, release the button.
English 