Get Troubleshooting -> Changing a bulb Guide for Citroen Dispatch Van Second Generation (2007-2015)

Changing a bulb

Type A

Entirely glass bulb: pull

gently as it is fitted by

pressure.

Type B

Bayonet bulb: press

on the bulb then turn it

anticlockwise.

Type C

Halogen bulb: release

the retaining spring from

its housing.

Halogen bulbs must be changed after

the headlamp has been off for several

minutes (risk of serious burns). Do not touch

the bulb directly with your fingers, use lint-

free cloths.

CHANGING A BULB

TYPES OF BULB

When each operation has been completed,

check the operation of the lights.

Various types of bulb are installed on your vehicle. To remove them:

Changing a bulb

-

Ensure that the cover is refitted 3. Direction indicators

FRONT LIGHTS

correctly over its entire periphery to

guarantee sealing.

Type B, PY 21 W - 21 W (amber)

Open the bonnet. To access the bulbs, reach

behind the headlamp unit.

-

Turn the bulb holder a quarter turn

anticlockwise.

Carry out the operations in reverse order to

refit each bulb.

2. Side lights

Type A, W 5 W - 5 W

Remove the bulb by pressing it lightly

while turning it anticlockwise.

-

Remove the cover by pulling the

flexible rubber tab.

Change the bulb.

-

Remove the bulb holder fitted by

pressure by pulling the connector.

1. Dipped headlamps/Main beam headlamps

Type C, H4 - 55 W

-

Change the bulb.

-

Remove the centre cover by pulling the

flexible rubber tab.

Ensure that the cover is refitted 4. Fog lamps

correctly over its entire periphery to

guarantee sealing.

Type C, H1 - 55 W

-

Disconnect the electrical connector.

Release the retaining spring.

Consult a CITROËN dealer.

Change the bulb taking care to align

the metal part with the grooves on the

light.

7

Changing a bulb

High pressure washing

When using this type of washing on

stubborn dirt, do not persist on the

headlamps, the lights and their surrounds to

avoid damaging their coating and their seal.

Front/Rear

DIRECTION INDICATOR SIDE

REPEATER

COURTESY LIGHTS

Type A, 12 V 5 W - 5 W

Type A, WY 5 W (amber)

-

Push the repeater towards the rear and

disengage it.

-

Unclip the lens by sliding a screwdriver

in the slots on each side of the courtesy

light.

Support the connector and turn the bulb

holder a quarter turn to the left.

-

Pull the bulb and change it.

Turn the bulb a quarter turn to the left,

remove it and change it.

Clip the lens in its housing and ensure

that it is secured correctly.

When refitting, engage the repeater

towards the rear and bring it towards the

front.

Amber coloured bulbs (direction indicators

and side repeaters) must be replaced with

bulbs of identical specification and colour.

Changing a bulb

REAR LIGHTS

-

Identify the faulty bulb then open

the rear doors to 180°. Refer to the

"Accesses" section of chapter 2.

-

Move aside the 8 tabs then extract the

bulb holder.

For further information concerning the bulbs,

refer to the "Types of bulb".

Remove the faulty bulb by pressing it

lightly while turning it anticlockwise.

-

Remove the two fixing nuts.

1. Brake lights/side lights

Pull the lens block from the outside.

Change the bulb.

Type B, P21/5 W - 21/5 W

Holding the light, disconnect the

electrical connector.

2. Direction indicators

Type B, PY 21 W - 21 W (amber)

When refitting, take care to correctly

reposition:

3. Reversing lights

-

the 8 tabs,

T

ype B, P21 W - 21 W

the two white lugs in the two rubber

holes to maintain the sealing of the light,

4. Fog lamps

Type B, P21 W - 21 W

-

the supply wire to avoid trapping it.

7

Changing a bulb

NUMBER PLATE LIGHTS

THIRD BRAKE LIGHT

Type B, P21 W - 21 W

Type A, W 5 W - 5 W

Light located on the outside (hinged doors)

Light located on the inside (tailgate)

With tailgate

-

Unscrew the two screws using a Torx^TM

-

Unscrew the two screws using a Torx^TM

-

Move aside the plastic lens using a

screwdriver, on the point indicated by

the arrow.

screwdriver with 20 socket.

-

Remove the light.

Change the bulb.

-

Remove the plastic cover.

Remove the bulb holder moving aside

the two tabs.

-

Change the bulb.

Replace the plastic lens and press on it.

Type B, P21 W - 21 W

-

Remove the faulty bulb by pressing it

lightly while turning it anticlockwise.

With hinged doors

Light on high door

Change the bulb.

-

Unclip the interior trim.

-

Remove the screws using an 8 wrench.

Disconnect the connector by moving

aside its tab.

Remove the faulty bulb by pressing it

lightly while turning it anticlockwise.

-

Remove the plastic cover.

-

Change the bulb.

Turn the bulb holder a quarter turn

anticlockwise.

-

Change the bulb.

Troubleshooting -> Changing a bulb for Your Citroen Dispatch Van Second Generation (2007-2015)

Related Topics

Troubleshooting

Popular Owner Manuals

Latest Owner Manuals