"ISOFIX" mountings
Your vehicle has been approved in accordance with the latest ISOFIX regulations.
The seats, represented below, are fitted with regulation ISOFIX mountings:
To secure the child seat to the TOP TETHER:
-
remove and stow the head restraint before
installing the child seat on this seat (refit it
after the child seat has been removed),
open the TOP TETHER cover by pulling its
cut-out,
pass the child seat strap behind the seat
backrest, centred between the holes for the
head restraint rods,
-
-
-
a ring B, located under a cover on the back
of the top of the seat backrest, referred to as
the TOP TETHER for fixing the upper strap.
Its position is indicated by a marking.
-
-
secure the upper strap fixing to the ring B,
tighten the upper strap.
Located on the back of the seat backrest, the
top tether is used to secure the upper strap of
child seats that have one. This device limits
forward tipping of the child seat, in the event of
a front impact.
The ISOFIX mountings are three rings for each seat:
The incorrect installation of a child seat
in a vehicle compromises the child's
protection in the event of an accident.
Observe strictly the fitting instructions
provided with the child seat.
This ISOFIX mounting system ensures fast,
reliable and safe fitting of the child seat in your
vehicle.
The ISOFIX child seats are fitted with
two latches which are secured easily on the
two rings A.
Some also have an upper strap (or top tether)
which is attached to ring B.
-
two rings A, located between the vehicle
seat back and cushion, indicated by a
marking,
For information on the possibilities
for fitting ISOFIX child seats to your
vehicle, refer to the table of seating
positions.
English 
