2024-2026 Cupra Terramar SUV Fuel and exhaust gas cleaning User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Fuel and exhaust gas cleaning for Your Cupra Terramar SUV First Generation (2024-2026)

Fuel and exhaust gas cleaning
333
Refuelling
Fuel and exhaust gas
cleaning
Refuelling
Safety warnings regarding fuel
handling
WARNING
Fuel is highly ammable and can cause seri-
ous burns and other injuries.
●
Before refuelling, disconnect the auxiliary
heater ›››page155, ›››page155.
●
When refuelling, turn o the engine and
turn o the ignition for safety reasons.
●
The fuel system of PHEV models is pressur-
ized to prevent petrol vapours from escaping
into the atmosphere.
●
Do not smoke when lling the fuel tank or
a canister. Naked ames are forbidden in the
vicinity due to the risk of explosion.
●
Observe legislation governing the use,
storage and carrying of a spare fuel canister
in the vehicle.
●
For safety reasons we do not recommend
carrying a spare fuel canister in the vehicle.
In an accident the canister could be dam-
aged and could leak.
●
If, in exceptional circumstances, you have
to carry a spare fuel canister, please observe
the following points:
–
Never ll fuel into the spare fuel canister
if it is inside or on top of the vehicle. This
could cause an explosion. Always place the
canister on the ground to ll it.
–
Insert the lling nozzle as far as possible
into the spare fuel canister.
–
If the spare fuel canister is made of
metal, the lling nozzle must be in contact
with the canister during lling. This helps
prevent an electrostatic charge building
up.
–
Never spill fuel in the vehicle or in the
luggage compartment. Fuel vapour is ex-
plosive. Risk of fatal accident!
NOTICE
●
If any fuel is spilt onto the vehicle, it should
be removed immediately. It could otherwise
damage the paintwork.
●
Never run the tank completely dry. The
catalytic converter can be damaged.
For the sake of the environment
Do not overll the fuel tank, it may cause the
fuel to overow if it becomes warm.
Note
There is no emergency mechanism for the
manual release of the fuel tank ap. If nec-
essary, request assistance from specialised
personnel.
Refuelling
Fig.202 Fuel tank ap with tank cap
attached.
The fuel tank ap is on the rear right of the
vehicle.
●
The tank ap is unlocked when the car is un-
locked using the central locking remote con-
trol ›››page104.
Hybrid vehicles: Use the
button on the driv-
er’s door to release the tank ap ›››page334.
●
Open the fuel tank ap by pressing on the
retainer zone.
●
Unscrew the cap by turning it to the left.
334
Fuel and exhaust gas cleaning
1
2
3
●
Place it in the space on the hinge of the open
ap ›››Fig.202.
●
Start refuelling. The tank is full as soon as
the pump’s automatic nozzle cuts o the fuel
supply. Do not try to put in more fuel after the
nozzle cuts out, as this will ll the expansion
chamber in the fuel tank.
●
Unscrew the cap by turning it to the right as
far as it will go.
●
Close the lid.
The correct fuel grade for your vehicle is given
on a sticker on the inside of the fuel tank
ap. Further notes on fuel can be found at
›››page334.
The capacity of your vehicle's fuel tank is given
in ›››page411.
Hybrid vehicles
Every 6 months it is necessary to run on petrol
until the control lamp switches o and then
the tank must be relled. This is necessary to
ensure that the system works properly, as well
as the fuel quality required for driving with pet-
rol.
Purging the fuel tank
✓ Valid for: hybrid vehicles.
Fig.203 Driver’s door: tank ap release.
Before refuelling the fuel system must be dep-
ressurised ›››
in Safety warnings regard-
ing fuel handling on page333. To do this,
press the button on the driver’s door.
An audible sound will be played and a warning
will be displayed on the instrument cluster dis-
play.
After a few seconds the fuel tank ap will un-
lock and remain unlocked for a few minutes. If
you have not refuelled after this time, you must
press the button again before refuelling.
Avoid touching the fuel tank ap lock button
›››
Fig.202 (arrow). The system will interpret
that you have nished and cannot continue
refuelling. Press the button on the driver’s
door again to continue.
Fuel types
Identication of fuels
Fig.204 Identication of fuels according to
European Union (EU) Directive 2014/94/
Fuels are identied by dierent symbols on
the pump and on your vehicle's tank ap
(country dependent). This identication avoids
confusion when selecting the fuel
Means petrol with a maximum of 5%
Ethanol.
Means petrol with a maximum of 10%
Ethanol.
Means petrol with a maximum of 20%
Ethanol.
Fuel and exhaust gas cleaning
335
Engine management and emissions control system
4
5
6
Diesel according to EN590 standard. The
number indicates the maximum percent-
age of Biodiesel in the fuel. “B7” means a
maximum of 7% Biodiesel.
Synthetic diesel according to the EN15940
standard.
Natural gas: “CNG” means Compressed
Natural Gas
Type of petrol
The correct grade of petrol is listed inside the
fuel tank ap.
The vehicle is equipped with a catalytic con-
verter and must only be run on unleaded pet-
rol. The petrol must comply with the standard
EN 228 and be sulphur-free. Follow the regu-
lations of the country you are driving in. The
types of petrol are dierentiated by using the
octane numbers (RON) or via the anti-knock
index (AKI).
Super unleaded petrol 95 octane petrol or
normal 91 octane petrol at least
We recommend refuelling with super 95 oc-
tane petrol (91 AKI). If not available, normal 91
octane petrol (87 AKI) (with a slight power loss)
may be used.
Super unleaded petrol, 95 octanes at least
You should use super 95 octane petrol (91 AKI)
at least.
If super petrol is not available, if necessary, use
normal 91 octane petrol (87 AKI). In this case
only use moderate engine speeds and a light
throttle. Refuel with super as soon as possible.
Unleaded super plus 98 octane petrol or su-
per 95 octane petrol at least
We recommend refuelling with super plus 98
octane petrol (93 AKI). If not available: super 95
octane petrol (91 AKI) (with a slight power loss).
If super petrol is not available, if necessary, use
normal 91 octane petrol (87 AKI). In this case
only use moderate engine speeds and a light
throttle. Refuel with super as soon as possible.
NOTICE
●
Fuels with a high percentage of ethanol,
e.g. E30 - E100 button must not be used. The
fuel system would be damaged.
●
A single refuelling with leaded fuel or other
metal additives entails a permanent deteri-
oration of the eectiveness of the catalytic
converter.
●
Only petrol additives that have been ap-
proved by SEAT S.A. should be used. Prod-
ucts containing substances to increase the
octane rating or decrease knocking may con-
tain metal additives that damage the engine
and catalytic converter. These type of prod-
ucts must not be used.
●
Do not use fuels shown in the pump as con-
taining metals. LRP (lead replacement petrol)
fuels contain high concentrations of metal
additives. Risk of engine damage!
●
High engine speed and full throttle can
damage the engine when using petrol with
an octane rating lower than the correct grade
for the engine.
Note
●
Fuel with an octane rating higher than the
one required by the engine can be used.
●
In countries in which there is no sulphur-
free fuel, fuel with a low sulphur content may
also be used.
Engine management and
emissions control system
Introduction
WARNING
Due to the high temperatures reached by the
exhaust gas scrubbing system, you should
not park your vehicle near a surface that can
catch re easily. Fire hazard!
336
Fuel and exhaust gas cleaning
WARNING
Do not apply wax underneath the vehicle
around the area of the exhaust system: Fire
hazard!
Catalytic converter
To maintain the useful life of the catalytic
converter
●
Only use unleaded petrol with petrol en-
gines.
●
Never run the fuel tank dry.
●
When changing or adding engine oil, do not
exceed the necessary amount ›››page362,
Checking and topping up the engine oil
level.
●
Never tow the vehicle to start it, use jump
leads if necessary ›››page341.
If you notice misring, uneven running or loss
of power when the car is moving, have the
vehicle inspected by a specialised workshop.
In general, the emissions warning lamp will
light up when any of these symptoms occur.
If this happens, any unburnt fuel can enter
the exhaust system and escape into the at-
mosphere. The catalytic converter can also be
damaged by overheating.
NOTICE
Never run the fuel tank completely dry be-
cause an irregular fuel supply can cause igni-
tion faults. This allows unburnt fuel to enter
the exhaust system, which could cause over-
heating and damage the catalytic converter.
For the sake of the environment
Even when the emission control system is
working perfectly, there may be a smell of
sulphur from the gases on occasions. This
depends on the sulphur content of the fuel
used. This can quite often be avoided by
changing to another brand of fuel.
Particulate lter
The particulate lter eliminates most of the
soot from the exhaust gas system. Under nor-
mal driving conditions the lter cleans itself.
If the lter does not clean itself (e.g. if short
journeys are made continuously), it becomes
blocked with soot and the following indication
is displayed to the driver:
Particulate lter: cleaned while the vehi-
cle is moving. See Manual.
The particulate lter needs cleaning (regener-
ation).
Regeneration of the petrol particulate lter
(except TSI 2.0l petrol engines)
Requirements for the regeneration journey:
the engine must be at operating temperature.
●
Drive at a speed of between 50-120km/h
(31-75mph). This increases the temperature
and burns the soot in the lter ›››page337.
●
Consider the legal speed limits as well as the
recommended gears.
●
End the regeneration journey once the con-
trol warning lamp has gone out.
If the warning lamp stays on after 30 minutes
of running in regeneration mode, have a speci-
alised workshop repair the fault.
Regeneration of the particulate lter (only
for 2.0l TSI petrol engines)
Requirements for the regeneration journey:
the engine must be at operating temperature.
●
Drive at a speed of at least 80 km/h
›››page337.
●
Completely remove your foot from the ac-
celerator pedal for a few seconds to let the
vehicle roll with the gear engaged.
●
Consider the legal speed limits as well as the
recommended gears.
●
Repeat this procedure (accelerate and let
roll) until the control lamp turns o.
Fuel and exhaust gas cleaning
337
Engine management and emissions control system
This procedure involves an autonomous par-
ticulate lter cleaning process and may take
some time.
If the warning lamp does not turn o, go im-
mediately to a specialised workshop to repair
the fault.
WARNING
Always adjust your speed to suit the weather
conditions, roads, braking distance and traf-
c if the particulate lter is in its regenera-
tion phase. Route recommendations should
never make you disregard each country's
specic traic regulations.
Note
If during the particulate lter regeneration
process you also get a fuel reserve warning ,
the process may be interrupted. Refuel and
continue with the particulate lter regenera-
tion process.
NOTICE
●
When the exhaust system detects that the
particulate lter is close to saturation, the
self-cleaning function of this system recom-
mends optimal driving for this function.
●
Due to the high temperatures caused by
the regeneration of the particulate lter, it is
possible that the radiator fan will activate af-
ter stopping the engine, even it its operating
temperature has not been reached.
●
Noise, smells and high idle speeds can oc-
cur during regeneration.
●
Always use the correct engine oil and the
correct fuel to make sure the useful life of
the particulate lter is not aected. Also
avoid making short trips all the time.
Troubleshooting
Fault in the emission control system.
The indicator lamp lights up yellow.
Reduce speed and drive carefully to the near-
est specialised workshop to have the engine
checked.
Combustion failures that can damage
the catalytic converter.
The control lamp ashes yellow.
Reduce speed and drive carefully to the near-
est specialised workshop to have the engine
checked.
Particulate lter blocked
The indicator lamp lights up yellow
›››page336..
Petrol engine management fault
The indicator lamp lights up yellow.
Have the engine checked as soon as possible
by a specialised workshop.
When the ignition is switched on, the lamp
lights up and should go o once the engine
has started.
NOTICE
While the control lamps , or are on,
there might be faults in the engine, fuel con-
sumption may go up and the engine might
lose power.

Related Topics

Popular Owner Manuals