11
01
Instruments
Activation/Deactivation
detergent or solvent products, due to the risk
of scratching the projection blade or damaging
the non-reflective coating.
C. If the vehicle is so equipped, inter-vehicle
distance information, lane departure warning
system information, lane positioning assist
information, and automatic emergency
braking alerts.
►ꢀ With the engine running, press button 1 to
activate the system and deploy the projection
blade.
►ꢀ Press and hold button 2 to deactivate the
system and retract the projection blade.
The state of the system is saved when the engine
is switched off and restored on restarting.
Warning and indicator
lamps
D. If the vehicle is so equipped, navigation
information.
Displayed as symbols, the warning and indicator
lamps inform the driver of the occurrence of a
malfunction (warning lamps) or of the operating
status of a system (operation or deactivation
indicator lamps). Certain lamps light up in two
ways (fixed or flashing) and/or in several colours.
For more information on Navigation, refer
to the Audio and telematics section.
Height adjustment
►ꢀ With the engine running, adjust the display to
the desired height using the buttons 4:
• up to move the display up,
Selector
• down to move the display down.
Associated warnings
Brightness adjustment
The illumination of a lamp may be accompanied
by an audible signal and/or a message displayed
in a screen.
Relating the type of alert to the operating status
of the vehicle allows you to determine whether
the situation is normal or whether a fault has
occurred: refer to the description of each lamp for
further information.
►ꢀ With the engine running, adjust the brightness
of the information display using the buttons 3:
• on the "sun" to increase the brightness,
• on the "moon" to decrease the brightness.
When stationary or while driving, no
objects should be placed around the
projection blade (or in its recess) so as not to
impede its movement and correct operation.
When the ignition is switched on
Certain red or orange warning lamps come on for
a few seconds when the ignition is switched on.
These warning lamps should go off as soon as the
engine is started.
For more information on a system or a function,
refer to the corresponding section.
1. On.
In certain extreme weather conditions
(rain and/or snow, bright sunshine, etc.),
the head-up display may not be legible or may
suffer temporary interference.
To clean the projection blade, use a clean, soft
cloth (such as a spectacles cloth or microfibre
cloth). Do not use a dry or abrasive cloth, or
2. Off (long press).
3. Brightness adjustment.
4. Display height adjustment.
English 
