2009-2016 DS 3 4 Door CHECKS -> Checks (Battery, Filters, etc) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

CHECKS -> Checks (Battery, Filters, etc) for Your DS 3 4 Door First Generation (2009-2016)

Checks  
Unless otherwise indicated, check these components in accordance with the manufacturer's service schedule and according to your engine.  
Otherwise, have them checked by a CITROËN dealer or a qualified workshop.  
12 V battery  
Air filter and passenger compartment filter Particle filter (diesel)  
The battery does not require any maintenance.  
Refer to the manufacturer's  
service schedule for details of the  
replacement intervals for these  
components.  
The start of saturation of the  
particle filter is indicated by the  
temporary illumination of this warning lamp  
accompanied by a message in the multifunction  
screen.  
As soon as the traffic conditions permit,  
regenerate the filter by driving at a speed of at  
least 40 mph (60 km/h) until the warning lamp  
goes off.  
However, check that the terminals are clean  
and correctly tightened, particularly in summer  
and winter.  
When carrying out work on the battery, refer  
to the "12 V battery" section for details of the  
precautions to be taken before disconnecting  
the battery and following its reconnection.  
Depending on the environment (e.g. dusty  
atmosphere) and the use of the vehicle (e.g.  
city driving), replace them twice as often if  
necessary.  
A clogged passenger compartment filter may  
have an adverse effect on the performance  
of the air conditioning system and generate  
undesirable odours.  
If the warning lamp stays on, this indicates a  
low additive level.  
On a new vehicle, the first particle  
filter regeneration operations may be  
accompanied by a "burning" smell,  
which is perfectly normal.  
Following prolonged operation of the  
vehicle at very low speed or at idle,  
you may, in exceptional circumstances,  
notice the emission of water vapour at  
the exhaust on acceleration. This does  
not affect the behaviour of the vehicle  
or the environment.  
The presence of this label, in particular with  
the Stop & Start system, indicates the use of  
a specific 12 V lead-acid battery with special  
technology and specification. The involvement  
of a CITROËN dealer or a qualified workshop  
is essential when replacing or disconnecting  
the battery.  
Oil filter  
Replace the oil filter each time the  
engine oil is changed.  
Refer to the manufacturer's  
service schedule for details of  
the replacement interval for this  
component.  
247  
Checks  
Manual gearbox  
Brake pads  
Parking brake  
The gearbox does not require any  
Brake wear depends on the style  
If excessive travel or a loss of  
maintenance (no oil change).  
Refer to the manufacturer's service  
schedule for the checking interval for  
this component.  
of driving, particularly in the case  
of vehicles used in town, over short  
distances. It may be necessary to have  
the condition of the brakes checked,  
even between vehicle services.  
effectiveness of this system is  
noticed, the parking brake must be  
checked, even between two services.  
Checking this system must be done by a  
CITROËN dealer or a qualified workshop.  
Unless there is a leak in the circuit, a drop in  
the brake fluid level indicates that the brake  
pads are worn.  
Electronic gearbox  
The gearbox does not require any  
maintenance (no oil change).  
Brake disc wear  
Only use products recommended by  
CITROËN or products of equivalent  
quality and specification.  
In order to optimise the operation of  
units as important as those in the  
braking system, CITROËN selects and  
offers very specific products.  
Refer to the manufacturer's service  
schedule for details of the checking  
interval for this component.  
For information on checking brake  
disc wear, contact a CITROËN dealer  
or a qualified workshop.  
Automatic gearbox  
The gearbox does not require any  
maintenance (no oil change).  
Refer to the manufacturer's service  
schedule for details of the level  
checking interval for this component.  
After washing the vehicle, dampness,  
or in wintry conditions, ice can form  
on the brake discs and pads: braking  
efficiency may be reduced. Make light  
brake applications to dry and defrost  
the brakes.  

Related Topics

Popular Owner Manuals