Lighting and visibility -> Changing a wiper blade for Your DS 7 Crossback 4 Door First Generation (2017-2022)

78  
04  
Lighting and visibility  
►ꢀ Within one minute of switching off the  
ignition, any operation of the wiper control stalk  
will position the wiper blades vertically.  
►ꢀ Proceed with the desired operation or the  
replacement of the wiper blades.  
Take care not to hold the arms at the jet  
locations.  
Do not touch the wiper blades. Risk of  
irreparable deformation.  
Do not release them while moving them. Risk  
of damaging the windscreen!  
Rear screenwash  
►ꢀ Turn the ring all the way towards the  
dashboard and hold.  
The screenwash and the wiper operate for as long  
as the ring remains turned.  
A final wiping cycle is performed when  
screenwashing ends.  
After refitting a front wiper blade  
►ꢀ To return the wiper blades to their initial  
position, switch on the ignition and operate the  
wiper control stalk.  
►ꢀ Clean the windscreen using screenwash fluid.  
Do not apply "Rain X" type water-repellent  
products.  
Special position of the  
windscreen wipers  
This maintenance position is used for cleaning or  
replacement of the wiper blades. It can also be  
useful, in winter (ice, snow), to release the wiper  
blades from the windscreen.  
Changing a wiper blade  
►ꢀ Unclip the worn wiper blade closest to you and  
remove it.  
►ꢀ Install the new wiper blade and clip it to the  
arm.  
Removing/refitting at the front  
►ꢀ Repeat the procedure for the other wiper  
blade.  
►ꢀ Starting with the wiper blade closest to you,  
once again hold each arm by the rigid section,  
then guide it carefully onto the windscreen.  
To maintain the effectiveness of the flat  
wiper blades, it is advisable to:  
– handle them with care.  
– clean them regularly using soapy water.  
– avoid using them to hold cardboard on the  
windscreen.  
Removing/refitting at the rear  
►ꢀ Hold the arm by the rigid section and raise it  
as far as possible.  
►ꢀ Clean the rear screen using screenwash fluid.  
►ꢀ Unclip the worn wiper blade and remove it.  
►ꢀ Install the new wiper blade and clip it to the  
arm.  
►ꢀ Once again hold the arm by the rigid section,  
then guide it carefully onto the rear screen.  
– replace them at the first signs of wear.  
Before removing a front wiper blade  
►ꢀ Carry out these wiper blade replacement  
operations from the driver's side.  
►ꢀ Starting with the wiper blade farthest from  
you, hold each arm by the rigid section and raise it  
as far as possible.