76
04
Lighting and visibility
– when reverse gear is engaged.
Automatic adjustment of the
Full LED technology headlamps
Without AUTO wiping
Headlamp adjustment
This system automatically adjusts the height of
the headlamp beams according to the load in the
vehicle.
Manual adjustment of halogen
or xenon headlamps
In the event of a malfunction, this warning
lamp comes on on the instrument panel,
accompanied by the display of a message and an
audible signal.
The system then places the headlamp beams in
the lowest position.
Have the system checked by a dealer or a
qualified workshop.
With AUTO wiping
Windscreen wipers
Do not touch the "Full LED" technology
headlamps - risk of electrocution!
To avoid causing a nuisance to other road users,
the height of these headlamp beams should be
adjusted according to the load in the vehicle.
Wiper control stalk
In wintry conditions, remove snow, ice or
frost present on the windscreen, around
the wiper arms and blades and on the
0
1
Driver only or driver + front passenger.
5 people.
2
3
5 people + loads in the boot.
Driver only + loads in the boot.
►ꢀ To select the wiping speed: raise or lower the
stalk to the desired position.
4 5 6 Not used.
windscreen seal, before operating the wipers.
Fast wiping (heavy rain)
The initial setting is position "0".
Normal wiping (moderate rain)
Do not operate the wipers on a dry
windscreen. Under extremely hot or cold
conditions, ensure that the wiper blades are
not stuck to the windscreen before operating
the wipers.
Intermittent wiping (proportional to the
vehicle’s speed)
Off
English 
