Deactivating Speed Control
Note: The Speed Control setting
cannot be performed under the
following conditions:
The Speed Control will cancel if the
vehicle speed decreases below
16 mph (25 km/h) when climbing a
steep incline.
Push the OFF/CAN button. The
warning light (amber) in the
instrument cluster turns off.
Automatic Transmission: the
gear selector is in the PARK or
NEUTRAL position.
When A Speed Has Been Set: the
warning light (green) in the
instrument cluster is illuminated, push
and hold the OFF/CAN button or push
the OFF/CAN button twice to
deactivate.
The Speed Control may cancel at
about 9 mph (15 km/h) below the
preset speed such as when climbing a
long, steep incline.
Manual Transmission: the gear
selector is in the NEUTRAL position or
when the clutch is disengaged (clutch
is depressed).
The vehicle’s set speed is displayed in
the instrument cluster.
When A Speed Has Not Been Set:
the
Increasing Speed
The parking brake is applied.
warning light (amber) in the
instrument cluster is illuminated, push
the OFF/CAN button to deactivate.
Release the SET (-) button at the
desired speed, otherwise the speed will
continue decreasing while the SET (-)
button is pushed and held (except
when the accelerator pedal is
depressed).
To increase speed using the Speed
Control buttons:
Setting A Desired Speed
Push the RES (+) button and hold it,
your vehicle will accelerate. Release the
button at the desired speed.
Proceed as follows:
1. Activate the Speed Control device
by pushing the ON button. The cruise
warning light (amber) illuminates.
Push the RES (+) button and release
it immediately, to adjust the set speed.
Multiple pushes of the button will
increase the set speed according to the
number of times it is pushed.
Note:
Release the SET (-) button at the
desired speed, otherwise the speed
will continue decreasing while the SET
(-) button is pushed and held (except
when the accelerator pedal is
depressed).
2. Accelerate to the desired speed,
which must be more than 25 mph
(40 km/h).
Increasing speed with a single RES
(+) button operation:
3. Set the Speed Control by pushing
the SET (-) button at the desired speed.
The Speed Control is set at the
moment the SET (-) button is pushed.
Release the accelerator pedal
On a steep grade, the vehicle may
momentarily slow down while
ascending, or speed up while
descending.
If the instrument cluster display for
vehicle speed is indicated in mph:
speed will increase in 1 mph
increments.
simultaneously. The
(green) illuminates.
warning light
If the instrument cluster display for
vehicle speed is indicated in km/h:
speed will increase in 1 km/h
increments.
165
English 
