Advertisement

Advertisement

Servicing and Care -> Replacing the Windscreen/Rear Window Wiper Blades for Your Fiat 500 C 2 Door Second Generation (2021-2025)

BRAKES  
REPLACING THE  
WINDSCREEN/REAR  
WINDOW WIPER  
BLADES  
WARNING  
Depending on the version/market, the  
vehicle may be equipped with  
mechanical wear detectors for the  
brake pads: one for each wheel  
assembly.  
64) Incorrect installation of electric and  
electronic devices may cause severe  
damage to your car. After purchasing your  
vehicle, if you wish to install any  
accessories (anti-theft, etc.), go to a Fiat  
Dealership, which will suggest the most  
suitable devices and advise you whether a  
higher capacity battery needs to be  
installed.  
WIPER BLADES  
When the brake linings are close to  
wearing out, pressing the brake pedal  
will generate a slight squeal: this lasts  
for about 100 km (the mileage varies  
with the driving style and route).  
In this case, it is still possible to  
continue driving, with caution.  
However, contact a Fiat Dealership as  
soon as possible to have the worn  
brake pads changed.  
Replace the blades if the rubber edge is  
deformed or worn. In any case, it is  
advisable to replace them  
approximately once a year.  
185) 186)  
WARNING  
RAISING THE  
WINDSCREEN WIPER  
BLADES  
5) Batteries contain substances which are  
very dangerous for the environment. It is  
advisable to contact a Fiat Dealership  
for battery replacement.  
Lift the windscreen wiper arm and  
position the blade so that it forms a 90°  
angle with the arm.  
REPLACING THE  
WINDSCREEN WIPER  
BLADES  
Proceed as follows:  
raise the wiper arm A fig. 133 and  
position the blade so that it forms  
an angle of 90° with the arm;  
press the button A and extract the  
blade C from the arm B;  
insert the new blade making sure it  
is locked into place.  
150  
WINDSCREEN WASHER  
NOZZLES  
REAR WINDOW WASHER  
NOZZLE  
If there is no jet, first check that there is  
fluid in the reservoir (see the "Checking  
fluid levels" paragraph in this chapter).  
Then check that the nozzle holes are  
not clogged; use a needle to unblock  
them if necessary.  
The rear window washer jets are fixed.  
The nozzle holder is on the rear window  
fig. 136.  
The screen washer jets can be oriented  
by adjusting the nozzle angles.  
F0S0137  
133  
REPLACING THE REAR  
WINDOW WIPER BLADE  
Proceed as follows:  
raise cover A fig. 134 and remove  
the arm from the car undoing the nut B  
that fastens it to the pivot pin;  
F0S0111  
136  
correctly position the new arm and  
tighten the nut fully;  
WARNING  
lower the cover.  
F0S0110  
135  
185) Driving with worn windscreen wiper  
blades is a serious hazard, because  
visibility is reduced in bad weather  
conditions.  
The jets should be directed at about  
1/3 of the height from the top edge of  
the windscreen fig. 135.  
186) If the window needs to be cleaned,  
make sure the device is deactivated or the  
key is on STOP.  
IMPORTANT In versions with a sun  
roof, make sure that the sun roof is  
closed before operating the front jets.  
F0S0109  
134  
151