Advertisement

Advertisement

Operating Your Vehicle -> Speed Control for Your Fiat 500 E 4 Door First Generation (2013-2019)

OPERATINGYOURVEHICLE  
SPEED CONTROL  
The speed control switches are located  
on the steering wheel.  
Cruise ON/OFF  
Push the ON/OFF button to activate the  
Speed Control.  
CRUISE READY will appear on the instru-  
ment cluster to indicate the Speed Con-  
trol is on.  
Push the ON/OFF button a second time  
to turn the system off.  
Set  
With the Speed Control on, push and  
release the SET – button to set a desired  
speed.  
NOTE:  
The set speed will be displayed on the cluster for approximately 2–3 seconds.  
Accel/Decel  
Once a speed is set, pushing the RES + button once or the SET – button once will in-  
crease or decrease the set speed approximately 1 mph (2 km/h).  
Push and hold the RES + button to accelerate in 5 mph (8 km/h) increments or push and  
hold the SET – button to decelerate in 5 mph (8 km/h) increments; release the button to  
save the new set speed.  
Resume  
To resume a previously selected set speed in memory, push the RES + button and  
release.  
Cancel  
Push the CANCEL button, or apply the brakes to cancel the set speed and maintain the  
set speed memory.  
Push the ON/OFF button to turn the system off and erase the set speed memory.  
32  
Downloaded from www.Manualslib.com manuals search engine  
OPERATINGYOURVEHICLE  
WARNING!  
Leaving the Electronic Speed Control system on when not in use is dangerous.You  
could accidentally set the system or cause it to go faster than you want.You could  
lose control and have a collision.Always leave the Electronic Speed Control system  
off when you are not using it.  
Electronic Speed Control can be dangerous where the system cannot maintain a  
constant speed.Your vehicle could go too fast for the conditions, and you could lose  
control.A collision could be the result. Do not use Electronic Speed Control in heavy  
traffic or on roads that are winding, icy, snow-covered or slippery.  
POWER WINDOWS  
The controls for the power windows are located on either side of the transmission push  
buttons.  
Power windows can be operated with the ignition in the ON/RUN position.  
Both windows have an Auto Down feature. Push the switch down past the detent and  
release to fully lower the window.  
Pull the switch upward to close the window.  
AUTOMATIC TEMPERATURE CONTROLS (ATC)  
Automatic Operation  
Push the AUTO button.  
Select the desired temperature by pushing the temperature control buttons.  
The system will maintain the set temperature automatically.  
33  
Downloaded from www.Manualslib.com manuals search engine