Get Servicing and Maintenance -> Exterior Care Guide for Fiat 600 SUV Second Generation (2023-2026)

Take the high-voltage battery to a

charge level close to 100%.

Adjust tyre pressure to the value

specified for full load.

Operate the climate control system

for at least 5 minutes, setting external

air and with fan set to maximum speed.

This operation will ensure appropriate

lubrication for the system, thus

minimising the possibility of damage to

the compressor when the system is

operated again.

Remove the black negative (−) cable

from the 12 V conventional battery

and attach a trickle charger to the

conventional battery terminals or keep

the 12 V conventional battery cables

connected and trickle charge from the

positive (+) and negative (−) terminals in

the engine compartment.

Check tyre pressure.

Fill up the washer fluid reservoir.

Check the coolant level.

Fit the number plate if necessary.

EXTERIOR CARE

144)

LOCKS

Every three months, check the

The locks are lubricated at the factory

using a high quality lock cylinder

grease. Use a de-icing agent only

when absolutely necessary, as this has

a degreasing effect and impairs lock

function. After using a de-icing agent,

have the locks regreased by a Fiat

Dealership.

battery's state of charge. If the state of

charge is below 30 percent, recharge

the battery to 30 percent.

Park the vehicle in a dry, well

PUTTING BACK INTO

OPERATION

ventilated place and slightly open the

windows. Set the PRND command to

P. Prevent the vehicle from rolling.

Do not apply the parking brake.

Open the bonnet, close all doors and

lock the vehicle.

When the vehicle is to be put back into

operation:

Connect the clamp to the negative

terminal of the conventional battery.

Initialise the power windows.

Check tyre pressure.

Fill up the washer fluid reservoir.

Check the engine oil level.

Check the coolant level.

WASHING

The paintwork of your vehicle is

exposed to environmental influences.

Bird droppings, dead insects, resin,

pollen and the like should be cleaned

off immediately, as they contain

aggressive constituents which can

cause paint damage.

Up to four weeks

Plug in the charging cable.

Four weeks to twelve months

Discharge the high voltage battery

until 30 percent remain on the battery

range indicator (battery symbol) on the

instrument panel display.

Do not plug in the charging cable.

Always store the vehicle in a place

with temperatures between −10 °C and

30 °C.

Fit the number plate if necessary.

PUTTING BACK INTO

OPERATION (ELECTRIC

VEHICLE)

Depending on the environment, clean

the vehicle frequently to remove salty

deposits (in coastal areas), soot (in

industrial areas) and mud/salts (in wet

or cold areas). These substances can

be highly corrosive.

When the vehicle is to be put back into

operation:

Connect the clamp to the negative

terminal of the conventional battery.

Initialise the power windows.

Vehicle storage at extreme

temperatures may cause damage to

the high voltage battery.

Contact a Fiat Dealership for advice

on removing stubborn stains requiring

251

compartment with a steam-jet or high-

pressure jet cleaner.

special products (such as tar or insect

removers).

When using a pressure washer, keep

the jet nozzle at a minimum distance

of 30 cm from the vehicle (particularly

when cleaning areas containing

chipped paint, sensors or seals).

332) 333) 334)

Preferably, have paint touch-ups

performed by a Fiat Dealership.

If using a vehicle wash, comply with

the vehicle wash manufacturer's

instructions. The windscreen wiper and

rear window wiper must be switched

off. Remove external accessories such

as roof racks etc. Be sure to lock the

doors and, depending on version,

move the electronic key away and

deactivate the "Hands Free boot

opening".

146) 147)

10)

EXTERIOR LIGHTS

Headlight and other light covers are

made of plastic. Do not use any

abrasive or caustic agents, do not use

an ice scraper, and do not clean them

dry.

324

JJ000579

Thoroughly rinse and leather-off the

vehicle. Rinse leather frequently. Use

separate leathers for painted and glass

surfaces: remnants of wax on the

windows will impair vision.

If you wash your vehicle by hand, make

sure that the insides of the wheel

housings are also thoroughly rinsed

out.

148)

POLISHING AND WAXING

Polishing is necessary only if the paint

has become dull or if solid deposits

have become attached to it.

Have the door hinges of all doors

greased by a Fiat Dealership.

NOTE For e-Hybrid versions in washing

tunnel stay engine ON and put the

selector command in position N

(neutral).

Do not use hard objects to remove

spots of tar. Use tar removal spray on

painted surfaces.

Plastic body parts must not be treated

with wax or polishing agents.

Clean edges and folds on opened

doors and the bonnet as well as the

areas they cover.

WINDOWS AND WIPER

BLADES

Take care not to direct the water jet

directly onto the electronic control

units, connectors and orange cables,

including the areas adjacent to them

(high-voltage circuit) and venting valves.

Have this operation performed by a

specialised workshop. After washing,

check that the various protective

components (e.g. rubber guards and

caps) have not been removed or

damaged.

Switch off wipers before handling in

their areas.

Clean bright metal mouldings with

a cleaning solution approved for

aluminium to avoid damages.

Do not wash the vehicle in bright

sunshine or extremely cold conditions.

145)

Use a soft lint-free cloth or chamois

leather together with window cleaner

and insect remover.

When cleaning the rear window from

inside, always wipe in parallel to the

heating element to prevent damage.

The image engraved on the fuses cover

fig. 324 reminds to not clean the engine

252

For mechanical removal of ice, use a

sharp-edged ice scraper. Press the

scraper firmly against the glass so that

no dirt can get under it and scratch the

glass.

HIGH-GLOSS PAINT

149)

IMPORTANT

Use a soft cloth and soapy water or a

pH neutral product.

332) For electric versions: before washing

the vehicle, always check that the charging

flap is closed correctly. Never wash the

vehicle while the battery is on charge

333) To avoid damaging the electrical

components, it is expressly prohibited to

use high-pressure washing in the engine

compartment or under the body. Do not

use a pressure greater than 80 bar when

washing the bodywork.

334) Never allow water or dust to enter

the connector or charging nozzle - risk

of electrocution or fire! Never connect /

disconnect the charging nozzle or cable

with wet hands - risk of electrocution!

Gently wipe the bodywork with a clean

microfibre cloth.

Clean smearing wiper blades with a

soft cloth and window cleaner. Also

make sure to remove any residues

such as wax, insect residues and

similar from the window.

Apply polish with the vehicle clean and

dry. Comply with the instructions for

use stated on the product.

UNDERBODY

Ice residues, pollution and continuous

wiping on dry windows will damage or

even destroy the wiper blades.

Some areas of the vehicle underbody

have a PVC undercoating while other

critical areas have a durable protective

wax coating.

WHEELS AND TYRES

Do not use high-pressure jet cleaners.

Clean rims with a pH-neutral wheel

cleaner.

After the underbody is washed, check

the underbody and have it waxed if

necessary.

WARNING

Rims are painted and can be treated

with the same agents as the body.

Bitumen / rubber materials could

damage the PVC coating. Have

underbody work carried out by a Fiat

Dealership.

144) Abrasive products and/or polishes

should not be used for cleaning the car.

Bird droppings must be washed off

immediately and thoroughly as the acid

they contain is particularly aggressive.

Avoid parking the vehicle under trees

(unless it is absolutely necessary). Remove

any resinous plant matter immediately

because, once it has dried, it may require

the use of abrasive and/or polishing

products to be removed, which are

strongly discouraged as they could

potentially alter the characteristics

PAINTING

(Electrified versions)

Before and after winter, wash the

underbody and have the protective wax

coating checked.

When painting the car in the oven, take

care not to exceed:

30 minutes at 70°C

20 minutes at 80°C

TOWING EQUIPMENT

Do not clean the coupling ball bar

with a steam-jet or high-pressure jet

cleaner.

PAINTWORK DAMAGE

Rectify minor paintwork damage with a

touch-up pen before rust forms. Have

more extensive damage or rust areas

repaired by a Fiat Dealership.

of the paintwork. Do not use pure

windscreen washer fluid for cleaning

the front windscreen and rear window;

dilute it min. 50% with water. Only use

pure screen washer fluid when strictly

253

Servicing and Maintenance -> Exterior Care for Your Fiat 600 SUV Second Generation (2023-2026)

Related Topics

Servicing and Maintenance

Popular Owner Manuals

Latest Owner Manuals