Advertisement

Advertisement

Download User Manual App

Quickly access user manual for free!

SERVICING AND CARE -> BODYWORK for Your Fiat Doblo Van 2010-2022

inflate tyres to +0.5 bar above the  
standard specified pressure and check  
it at intervals;  
use of "open" boxed sections to  
prevent condensation and pockets of  
moisture from triggering rust inside.  
BODYWORK  
PROTECTION AGAINST  
ATMOSPHERIC AGENTS  
do not drain the engine cooling  
system.  
VEHICLE EXTERIOR AND  
UNDERBODY WARRANTY  
The main causes of corrosion are the  
following:  
Your vehicle is covered by warranty  
against perforation due to corrosion of  
any original element of the structure  
or body.  
atmospheric pollution;  
salty air and humidity (coastal areas,  
or hot humid climates);  
seasonal environmental conditions.  
The abrasive action of wind-borne  
atmospheric dust and sand, as well as  
mud and gravel raised by other cars  
is also not to be underestimated.  
On your vehicle, Fiat has implemented  
the best manufacturing technologies  
to effectively protect the bodywork  
against corrosion.  
For the general terms of this warranty,  
refer to the Warranty Booklet.  
ADVICE FOR  
PRESERVING THE  
BODYWORK  
Paintwork  
Paintwork does not only serve an  
aesthetic purpose, but also protects the  
underlying sheet metal.  
These include:  
Touch up abrasions and scratches  
immediately to prevent rust formation.  
Use only original paint products for  
touch-ups (see “Bodywork paint  
identification plate” in the “Technical  
specifications” section).  
painting products and systems  
which give the vehicle particular  
resistance to corrosion and abrasion;  
use of galvanised (or pretreated)  
sheet metal, with high resistance to  
corrosion;  
Normal maintenance of paintwork  
consists in washing the vehicle: the  
frequency depends on the conditions  
and environment where the vehicle  
is used.  
spraying the underbody, engine  
compartment, wheelhouse internal  
parts and other parts with highly  
protective wax products;  
spraying of plastic parts, with a  
protective function in the more exposed  
points: underdoor, inner wing, edges,  
etc.;  
For example, it is advisable to wash the  
vehicle more often in areas with high  
levels of environmental pollution or on  
roads spread with salt.  
196  
To correctly wash the vehicle, proceed  
as follows:  
Exterior plastic parts should be cleaned  
in the same way as the rest of the  
vehicle. Where possible, do not park  
the vehicle under trees; the resinous  
substances released by many species  
give the paint a dull appearance and  
increase the possibility of corrosion.  
IMPORTANT Bird droppings should be  
washed off immediately and thoroughly  
as the acid they contain is particularly  
aggressive.  
IMPORTANT The washing should take  
place with the engine cold and the  
ignition key in the STOP position. After  
the washing operation, make sure  
that the various protections (e.g. rubber  
caps and guards) have not been  
removed or damaged.  
wash the bodywork using a low  
pressure jet of water;  
wipe a sponge with a slightly soapy  
solution over the bodywork, frequently  
rinsing the sponge;  
Headlights  
rinse well with water and dry with a  
jet of air or a chamois.  
IMPORTANT Never use aromatic  
substances (e.g. petrol) or ketones (e.g.  
acetone) for cleaning the plastic lenses  
of the front headlights.  
If you put the vehicle through a car  
wash, follow these recommendations:  
– remove the aerial from the roof so  
it does not get damaged;  
5)  
Windows  
– water added to a soapy solution  
should be used for washing;  
– rinse thoroughly to avoid soap marks  
staying on the bodywork or less visible  
parts.  
To clean glasses, use specific cleaning  
products. Use clean cloths to avoid  
scratching the glass or damaging the  
transparency.  
WARNING  
39) Some car washes with old-style blades  
and/or in a poor state of repair can  
IMPORTANT Wipe the inside surface of  
the rear window gently with a cloth in  
the direction of the filaments to avoid  
damaging the heater coils.  
damage the paintwork, facilitating the  
formation of lines that give the paint  
a dull/misty appearance, especially on dark  
colours. If this happens, lightly polish the  
paintwork with appropriate products.  
39)  
Dry the less visible parts with special  
care, such as the door frames, bonnet  
and the headlight frames, where water  
may stagnate more easily. It is a good  
idea to leave the vehicle outdoors  
for a while after washing it to give water  
time to evaporate.  
Engine compartment  
At the end of each winter, thoroughly  
wash the engine compartment, taking  
care to avoid spraying the water jet  
directly onto the electronic control units  
and the relay/fuse box on the left side  
of the engine compartment (driving  
direction). Have this operation  
WARNING  
Do not wash the vehicle after it has  
been left in the sun or with the bonnet  
hot: this may alter the shine of the  
paintwork.  
5) Detergents cause water pollution. The  
vehicle should be washed in areas  
equipped for collecting and purifying the  
liquid used in the washing process.  
performed at a specialised workshop.  
197