Get SERVICING AND CARE -> ENGINE COMPARTMENT Guide for Fiat Doblo Van 2010-2022

ENGINE COMPARTMENT

.

1.4 95CV versions

F0V0076

208

A. Engine oil filler – B. Engine oil dipstick – C. Engine coolant fluid – D. Windscreen washer fluid – E. Brake fluid – F. Battery – G. Power steering fluid

136)

31)

179

1.4 T-JET versions

F0V0390

209

A. Engine oil filler – B. Engine oil dipstick – C. Engine coolant fluid – D. Windscreen washer fluid – E. Brake fluid – F. Battery – G. Power steering fluid

136)

31)

180

1.3 MultiJet versions without DPF

F0V0187

210

A. Engine oil filler – B. Engine oil dipstick – C. Engine coolant fluid – D. Windscreen washer fluid – E. Brake fluid – F. Battery – G. Power steering fluid

136)

31)

181

1.3 MultiJet versions with DPF

F0V0189

211

A. Engine oil filler – B. Engine oil dipstick – C. Engine coolant fluid – D. Windscreen washer fluid – E. Brake fluid – F. Battery – G. Power steering fluid

136)

31)

182

1.3 Multijet Euro 6 versions

F0V0630

212

A. Engine oil filler – B. Engine oil dipstick – C. Engine coolant fluid – D. Windscreen washer fluid – E. Brake fluid – F. Battery – G. Power steering fluid

136)

31)

183

1.6 MultiJet versions

F0V0190

213

A. Engine oil filler – B. Engine oil dipstick – C. Engine coolant fluid – D. Windscreen washer fluid – E. Brake fluid – F. Battery – G. Power steering fluid

136)

31)

184

1.6 Multijet Euro 6 versions

F0V0615

214

A. Engine oil filler – B. Engine oil dipstick – C. Engine coolant fluid – D. Windscreen washer fluid – E. Brake fluid – F. Battery – G. Power steering fluid

136)

31)

185

2.0 MultiJet versions

F0V0160

215

A. Engine oil filler – B. Engine oil dipstick – C. Engine coolant fluid – D. Windscreen washer fluid – E. Brake fluid – F. Battery – G. Power steering fluid

136)

31)

186

ENGINE OIL

137)

32)

2)

WINDSCREEN/REAR

WINDOW WASHING FLUID

Check the oil level a few minutes after

stopping the engine (about 5 minutes)

with the vehicle parked on level ground.

Check the level is within the MIN. and

MAX. marks on the dipstick B fig. 208 -

fig. 209 - fig. 210 - fig. 211 - fig. 213 -

fig. 214 - fig. 215.

Remove the cap D fig. 208 - fig. 209 -

fig. 210 - fig. 211 - fig. 213 - fig. 214

- fig. 215, using the special tab, to add

fluid.

ENGINE COOLANT

The coolant level must be checked

when the engine is cold and must

range between the MIN and MAX

marks on the reservoir. If the level is

low, slowly pour a mixture of 50%

distilled water and 50% PARAFLU^UPby

PETRONAS LUBRICANTS through

the filler neck C fig. 208 - fig. 209 - fig.

210 - fig. 211 - fig. 213 - fig. 214 -

fig. 215, until the level approaches

MAX.

The mixture of 50% PARAFLU^UPand

50% distilled water protects against

freezing down to temperatures of

–35°C. For particularly harsh climate

conditions, we recommended using a

mixture of 60% PARAFLU^UPand 40%

distilled water.

Use a mixture of water and TUTELA

PROFESSIONAL SC35 fluid, in the

following concentrations:

The range between the MIN. and MAX.

marks corresponds to about 1 litre of

oil.

30% TUTELA PROFESSIONAL SC 35

and 70% water in summer.

50% TUTELA PROFESSIONAL SC 35

and 50% water in winter.

If the oil level is near or under the MIN

line, add oil through the filler Afig. 208 -

fig. 209 - fig. 210 - fig. 211 - fig. 213

- fig. 214 - fig. 215, until it reaches the

MAX line.

At temperatures below -20°C, use

undiluted TUTELA PROFESSIONAL SC

35 fluid.

Check fluid level through the reservoir.

Close cap D by pressing on the central

section.

The oil level must never exceed the

MAX reference.

Engine oil consumption

The maximum engine oil consumption

is usually 400 grams every 1000 km.

The engine needs to run in when the

vehicle is new, and therefore the engine

oil consumption can only be considered

stabilised after the first 5,000 - 6,000

km.

139)

BRAKE FLUID

Undo cap E fig. 208 - fig. 209 - fig. 210

- fig. 211 - fig. 213 - fig. 214 - fig. 215

and check that the liquid in the reservoir

is at the maximum level.

33)

138)

The fluid level in the reservoir must not

exceed the MAX mark.

IMPORTANT Oil consumption depends

on driving style and conditions of use

of the vehicle.

Use the brake fluid shown in the "Fluids

and lubricants" table (see "Technical

Specifications").

IMPORTANT After adding or changing

the oil, let the engine turn over for a few

seconds and wait a few minutes after

turning it off before checking oil level.

NB Carefully clean the reservoir cap E

and surrounding surfaces.

187

141) The symbol

, on the brake fluid

Take great care to ensure that

impurities do not enter the reservoir

when the cap is opened.

container indicates if a brake fluid is

synthetic or mineral-based. Using

a mineral-type fluid will damage the special

rubber seals of the braking system beyond

repair.

WARNING

For topping-up, always use a funnel

with integrated filter with mesh equal to

or lower than 0.12 mm.

136) Never smoke while working in the

engine compartment: gas and inflammable

vapours may be present, with the risk of

fire.

142) Prevent power steering fluid from

coming into contact with hot engine parts:

it is flammable.

IMPORTANT Brake fluid absorbs

moisture. For this reason, if the vehicle

is mainly used in areas with a high

degree of atmospheric humidity, the

fluid should be replaced at more

frequent intervals than specified in the

“Scheduled Servicing Plan”.

137) When the engine is hot, take care

when working inside the engine

compartment to avoid burns. Remember

that when the engine is hot, the fan may

operate: danger of injury. Scarves, ties and

other loose clothing might be pulled by

moving parts.

WARNING

31) When topping up, take care not to mix

up the various types of fluids: they are

not compatible with each other and could

seriously damage the vehicle.

138) The cooling system is pressurised. If

necessary, only replace the plug with

another original or the operation of the

system may be adversely affected. Do not

remove the reservoir plug when the engine

is hot: you risk scalding yourself.

34)

140) 141)

32) Do not add oil with specifications other

than those of the oil already existing in

the engine.

POWER STEERING FLUID

Check that the oil level with the vehicle

on flat ground and the engine cold is

between the MIN and MAX marks

on the reservoir body G fig. 208 - fig.

209 - fig. 210 - fig. 211 - fig. 213 - fig.

214 - fig. 215.

33) PARAFLU^UPanti-freeze is used in the

engine cooling system. Use the same

fluid as in the cooling system when topping

up. PARAFLU^UPcannot be mixed with

any other type of fluid. If this occurs, do not

start the engine and contact your Fiat

Dealership immediately.

139) Do not travel with the windscreen

washer fluid reservoir empty: the

windscreen washer is essential for

improving visibility. Some commercial

windscreen washer additives are

flammable. The engine compartment

contains hot components which may set it

on fire.

The level may exceed the MAX mark

when the oil is hot.

34) Prevent brake fluid, which is highly

corrosive, from coming into contact with

painted parts. Should it happen,

immediately wash with water.

If topping up is required, make sure the

oil you use has the same specifications

as that already in the system.

140) Brake fluid is poisonous and highly

corrosive. In the event of accidental

contact, immediately wash the affected

parts with water and mild soap. Then rinse

thoroughly. Call a doctor immediately if

swallowed.

35) Do not press on the power steering

end of travel with engine on for more than

8 consecutive seconds, since noise is

produced and there is a risk of system

damages.

142)

3)

35)

188

Download User Manual App

SERVICING AND CARE -> ENGINE COMPARTMENT for Your Fiat Doblo Van 2010-2022

Related Topics

SERVICING AND CARE

Popular Owner Manuals

Latest Owner Manuals