standard tyres. Their usage should
therefore be restricted in accordance
with their type approval.
RUBBER HOSES
WARNING
As far as the maintenance of the brake
system and fuel supply system rubber
hoses is concerned, follow the "Service
Schedule" in this chapter carefully.
Ozone, high temperatures and
prolonged lack of fluid in the system
may cause hardening and cracking of
the hoses, with possible leaks. Careful
checking is therefore necessary.
161) Remember that the road holding
qualities of your vehicle also depend on
the correct inflation pressure of the tyres.
162) If tyre pressure is too low, the tyre
may overheat and be severely damaged as
a result.
163) Do not switch tyres from the
right-hand side of the vehicle to the
left-hand side, and vice versa.
165)
Note When using snow tyres with a
maximum speed index below the one
that can be reached by the vehicle
(increased by 5%), place a notice in
the passenger compartment, plainly in
view, which states the maximum speed
allowed by the snow tyres (as per
EC Directive). All four tyres should be
the same (brand and track) to ensure
greater safety when driving and braking
as well as a good manoeuvrability.
Remember that you should not change
the rotation direction of the tyres.
164) Never submit alloy rims to
repainting treatments requiring the use
of temperatures exceeding 150°C. The
mechanical properties of the wheels could
be impaired.
BODYWORK
PROTECTION AGAINST
ATMOSPHERIC AGENTS
The main causes of corrosion are the
following:
atmospheric pollution;
salty air and humidity (coastal areas,
165) You must not exceed 160 km/h on
snow tyres with a “Q” mark; in any case,
make sure you stick to the rules of the
highway code.
166) Keep the vehicle's speed down when
snow chains are fitted; never exceed 50
km/h. Avoid potholes, do not drive over
steps or pavements, and do not drive long
distances over roads without snow, to
avoid damaging both your vehicle and the
road surface.
SNOW CHAINS
The use of snow chains should be in
compliance with local regulations of
each country. The snow chains may be
applied only onto the front wheel (drive
wheels).
Check the tension of the snow chains
after the first few metres have been
driven.
or hot humid climates);
seasonal environmental conditions.
The abrasive action of wind-borne
atmospheric dust and sand, as well as
mud and gravel raised by other cars is
also not to be underestimated.
On your vehicle, Fiat has implemented
the best manufacturing technologies
to effectively protect the bodywork
against corrosion.
166)
These include:
painting products and systems which
give the vehicle particular resistance to
corrosion and abrasion;
190
English 
