2015-2026 Fiat Fiorino SUV Servicing and Maintenance -> Wheels and Tyres User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Servicing and Maintenance -> Wheels and Tyres for Your Fiat Fiorino SUV Third Generation (2015-2026)

specialised technicians if they have  
been fitted for longer than 6 years.  
Remember to check the spare wheel  
very carefully;  
in the case of replacement, always fit  
new tyres, avoiding those of unknown  
origin;  
do not drain the engine cooling  
system.  
LIFTING THE  
VEHICLE  
If the vehicle needs to be lifted, go to a  
Fiat Dealership which is equipped with  
the arm hoist or workshop lift.  
if a tyre is changed, also change the  
inflation valve;  
WHEELS AND TYRES  
to allow even wear between the front  
and rear tyres, it is advisable to change  
them over every 1015 thousand  
kilometres, keeping them on the same  
side of the vehicle so as not to reverse  
the direction of rotation.  
245  
F0T0013  
Check the pressure of each tyre,  
including the space-saver spare wheel,  
approximately every two weeks and  
before long journeys: the pressure  
should be checked with the tyre rested  
and cold.  
It is normal for the pressure to increase  
when the vehicle is used; for the  
correct tyre inflation pressure, see the  
"Wheels" paragraph in the "Technical  
specifications" chapter.  
Incorrect pressure causes abnormal  
tyre wear fig. 245:  
A normal pressure: tread evenly worn;  
B low pressure: tread particularly worn  
at the edges;  
IMPORTANT NOTES  
As far as possible, avoid sharp  
braking, screech starts and violent  
shocks against pavements, potholes or  
other hard obstacles.  
Driving for long stretches over uneven  
161) 162) 163) 164)  
SNOW TYRES  
roads can damage the tyres;  
The Fiat Dealership will be happy to  
provide advice concerning the most  
suitable type of tyre for the customer's  
requirements.  
periodically check that the tyres have  
no cuts in the side wall, abnormal  
swelling or irregular tyre tread wear. Go  
to a Fiat Dealership if required;  
avoid overloading the car when  
travelling: this may cause serious  
damage to the wheels and tyres;  
if a tyre is punctured, stop  
For the type of tyre to be used, inflation  
pressures and the specifications of  
snow tyres, follow the instructions  
given in the "Wheels" paragraph in the  
"Technical specifications" chapter.  
The winter features of these tyres  
are reduced considerably when the  
tread depth is below 4 mm. Replace  
them in this case. Due to the specific  
characteristics of snow tyres, in  
normal weather conditions or on long  
motorway journeys, the performance  
of these tyres is lower than that of  
immediately and replace it to  
C high pressure: tread particularly worn  
in the centre.  
The tyres must be replaced when the  
tread is less than 1.6 mm thick. In any  
case, follow the laws in force in the  
country where you are driving.  
avoid damage to the tyre, the rim,  
suspension and steering system;  
tyres age even if they are not used  
much. Cracks in the tread and on  
the sidewalls are a sign of ageing. In  
any event, have the tyres checked by  
189  
standard tyres. Their usage should  
therefore be restricted in accordance  
with their type approval.  
RUBBER HOSES  
WARNING  
As far as the maintenance of the brake  
system and fuel supply system rubber  
hoses is concerned, follow the "Service  
Schedule" in this chapter carefully.  
Ozone, high temperatures and  
prolonged lack of fluid in the system  
may cause hardening and cracking of  
the hoses, with possible leaks. Careful  
checking is therefore necessary.  
161) Remember that the road holding  
qualities of your vehicle also depend on  
the correct inflation pressure of the tyres.  
162) If tyre pressure is too low, the tyre  
may overheat and be severely damaged as  
a result.  
163) Do not switch tyres from the  
right-hand side of the vehicle to the  
left-hand side, and vice versa.  
165)  
Note When using snow tyres with a  
maximum speed index below the one  
that can be reached by the vehicle  
(increased by 5%), place a notice in  
the passenger compartment, plainly in  
view, which states the maximum speed  
allowed by the snow tyres (as per  
EC Directive). All four tyres should be  
the same (brand and track) to ensure  
greater safety when driving and braking  
as well as a good manoeuvrability.  
Remember that you should not change  
the rotation direction of the tyres.  
164) Never submit alloy rims to  
repainting treatments requiring the use  
of temperatures exceeding 150°C. The  
mechanical properties of the wheels could  
be impaired.  
BODYWORK  
PROTECTION AGAINST  
ATMOSPHERIC AGENTS  
The main causes of corrosion are the  
following:  
atmospheric pollution;  
salty air and humidity (coastal areas,  
165) You must not exceed 160 km/h on  
snow tyres with a “Q” mark; in any case,  
make sure you stick to the rules of the  
highway code.  
166) Keep the vehicle's speed down when  
snow chains are fitted; never exceed 50  
km/h. Avoid potholes, do not drive over  
steps or pavements, and do not drive long  
distances over roads without snow, to  
avoid damaging both your vehicle and the  
road surface.  
SNOW CHAINS  
The use of snow chains should be in  
compliance with local regulations of  
each country. The snow chains may be  
applied only onto the front wheel (drive  
wheels).  
Check the tension of the snow chains  
after the first few metres have been  
driven.  
or hot humid climates);  
seasonal environmental conditions.  
The abrasive action of wind-borne  
atmospheric dust and sand, as well as  
mud and gravel raised by other cars is  
also not to be underestimated.  
On your vehicle, Fiat has implemented  
the best manufacturing technologies  
to effectively protect the bodywork  
against corrosion.  
166)  
These include:  
painting products and systems which  
give the vehicle particular resistance to  
corrosion and abrasion;  
190  

Related Topics

Popular Owner Manuals