REAR HEAD RESTRAINTS
HEAD RESTRAINTS
Upwards adjustment: raise the head
restraint until it clicks into place.
WARNING
11) 12)
FRONT HEAD
RESTRAINTS
Downward adjustment: press button
A fig. 12 and lower the head restraint.
11) All adjustments must be made with the
car stationary. Head restraints must be
adjusted so that the head, rather than the
neck, rests on them. Only in this case
they can protect your head correctly.
Upwards adjustment: raise the head
restraint until it clicks into place.
Downward adjustment: press button
A fig. 11 and lower the head restraint.
12) To make the best use of the head
restraint's protective action, adjust the
backrest so that you are sitting upright and
keep your head as close as possible to
the head restraint.
F1D0012
12
IMPORTANT If the rear seats are used,
always set the head restraints in the
"completely raised" position.
F1D0011
11
Removal
"Anti-Whiplash" device
Proceed as follows to remove the head
restraints:
The head restraints are equipped with
an “Anti-Whiplash” device, which
reduces the distance between head
and head restraint in the event of a rear
impact, thus mitigating the "whiplash"
effect.
raise the head restraints to their
maximum height;
press buttons A and B fig. 12 at the
side of the two supports, then remove
the head restraints by pulling them
upwards.
The head restraint may move when the
backrest is pressed by the occupant’s
torso or hand: this behaviour is caused
by the system and should not be
considered a malfunction.
14
English 
