REPLACING THE REAR
WINDOW WIPER BLADE
Rear window washer
LIFTING THE
VEHICLE
The rear window washer jets are fixed.
The nozzle holder is located above
the rear window.
Proceed as follows:
170)
raise the cover A fig. 133, undo the
nut B and remove the arm C;
If the vehicle needs to be raised, go to
a Fiat Dealership which is equipped
with arm lifts and workshop lifts fig.
134.
correctly position the new arm, fully
tighten the nut B then lower the cover
A.
WARNING
169) Driving with worn windscreen/rear
window wiper blades is a serious risk,
because visibility is reduced in bad
weather.
WARNING
64) Do not operate the windscreen wiper
with the blades lifted from the windscreen.
F1D0135
134
F1D0101
133
NOZZLES
WARNING
Windscreen washer
The windscreen washer jets can be
adjusted rotating the side notch with a
screwdriver. If there is no jet of fluid,
firstly check that there is fluid in the
reservoir (see the "Checking fluid levels"
paragraph in this chapter). Then check
that the nozzle holes are not clogged;
use a needle to unblock them if
necessary.
170) Lift the vehicle exclusively by
positioning the jack arms or the workshop
jack in the points illustrated.
145
English 
