❒
The warning light
U
will start flashing again: after it
ENGINE STARTING
has flashed the number of times that corresponds
to the second figure on the CODE card, press the
accelerator pedal to the floor and keep it there;
EMERGENCY START-UP
If the Fiat CODE system fails to deactivate engine
U
immobilising system the warning lights Y and
❒
❒
Do the same for the remaining figures on the
CODE card;
stay on and the engine cannot be started.
Once the final figure has been entered, keep the
To start the engine the emergency start-up can be
performed.
accelerator pedal pressed. The warning light
will light up for 4 seconds and then goes out.
Release the accelerator pedal;
U
Read the whole procedure carefully before trying to
carry it out. If you make a mistake, you must turn the
ignition key back to STOP and repeat the whole
operation from beginning.
❒
❒
Rapid flashing of the warning light
U
(for about 4
seconds) confirms the operation has been carried
out successfully;
Proceed as follows:
Start the engine by turning the ignition key from
MAR to AVV.
❒
Read the 5-figure electronic code given on the
CODE card;
If however the warning light
ignition key to STOP and repeat the procedure from
step one
U
stays on, turn the
❒
❒
Turn the ignition key to MAR;
Press and hold down the accelerator pedal. The
IMPORTANT After an emergency start-up, you should
contact a Fiat Dealership otherwise you will have to
repeat the procedure described each time you want to
start the engine.
warning light
U
turns on for about 8 seconds, and
then goes off;
❒
❒
Release the accelerator pedal and get ready to
count the flashes of the warning light;
U
Count the number of flashes that corresponds to
the first figure of the code on the CODE card, then
press the accelerator pedal and keep it there until
the
U
warning light comes on (for 4 seconds) and
then goes off; release the accelerator pedal;
200
English 
