The Reset procedure must be carried
out:
hold the MENU/
button down
This indication is displayed also after
the engine has been switched off and
then on again if the correct operating
conditions are not restored.
to go back to the standard screen
or main menu, depending on where you
are in the menu.
each time the tyre pressure is
modified or when even a single tyre is
replaced;
At the end of the Reset procedure the
display will show the "Reset saved"
message, indicating that the "self-
learning" has been started.
when tyres are rotated/inverted;
WARNING
when the space-saver wheel is
fitted.
63) If the system signals a pressure
decrease on a specific tyre, it is
recommended to check the pressure on all
four tyres.
Working conditions
Before carrying out the Reset
procedure, inflate the tyres to the rated
pressure values specified in the inflation
pressure table (see "Wheels" paragraph
in the "Technical specifications"
chapter).
The system is active for speeds above
15 km/h.
64) iTPMS does not relieve the driver from
the obligation to check the tyre pressure
every month; it is not even to be
considered a replacing system for
maintenance or a safety system.
In a few situations such as sporty
driving, particular conditions of the road
surface (e.g. icy, snowy, unsurfaced
roads...) the signalling may be delayed
or partial in detecting the contemporary
deflation of more than one tyre.
Under special conditions (e.g. vehicle
loaded asymmetrically on one side,
towing a trailer, damaged or worn tyre,
fitting the space-saver wheel, use of the
"Fix&Go Automatic" kit, fitting snow
chains, fitting different tyres on the
axles) the system may give false
indications or be temporarily
If the Reset procedure is not carried
out, in all above cases, the
warning
65) Tyre pressure must be checked with
tyres cold. Should it become necessary for
whatever reason to check pressure with
warm tyres, do not reduce pressure even
though it is higher than the prescribed
value, but repeat the check when tyres are
cold.
light may give false indications on
one or more tyres. To carry out the
Reset procedure, with the vehicle
stopped and the ignition device at
MAR, use the Setup Menu as follows:
press the MENU/
button briefly:
66) The iTPMS cannot indicate sudden
tyre pressure drops (for example when
a tyre bursts). In this case, stop the vehicle,
braking with caution and avoiding abrupt
steering.
the display will show the wording
"Reset";
press the + button or the button to
select ("Yes" or "No");
deactivated.
If the system is temporarily deactivated
67) The system only warns that the tyre
pressure is low: it is not able to inflate
them.
press the MENU/
button briefly:
the
warning light flashes for about
the display will show the wording
"Confirm";
75 seconds and then is continuously on
(at the same time, the display shows a
dedicated message).
68) Insufficient tyre inflation increases fuel
consumption, reduces the tread duration
and may affect the capacity to drive safely.
press the + button or the – button to
select ("Yes" to "Reset" or "No" to exit
the screen);
60
English 
