Get Maintenance and Specifications -> ENGINE OIL Guide for Ford Explorer SUV Fifth Generation (2005-2011)

Maintenance and Specifications

4. To attach the new wiper to the

wiper arm, align the cross pin and

keyway (denoted with the arrows)

and firmly press the wiper blade

into the wiper arm until an audible

snap is heard.

ENGINE OIL

Checking the engine oil

Refer to the scheduled maintenance information for the appropriate

intervals for checking the engine oil.

1. Make sure the vehicle is on level ground.

2. Turn the engine off and wait 15 minutes for the oil to drain into the

oil pan.

3. Set the parking brake and ensure the gearshift is securely latched in P

(Park).

4. Open the hood. Protect yourself from engine heat.

5. Locate and carefully remove the engine oil level dipstick.

• 4.0L V6 engine

356

2010 Explorer (exp)

Owners Guide, 2nd Printing

USA (fus)

Maintenance and Specifications

• 4.6L V8 engine

6. Wipe the dipstick clean. Insert the dipstick fully, then remove it again.

• If the oil level is between the lower and upper holes, the oil level

is acceptable, DO NOT ADD OIL.

• If the oil level is below the lower hole, add enough oil to raise the

level within the lower and upper holes.

• 4.0L V6 engine

357

2010 Explorer (exp)

Owners Guide, 2nd Printing

USA (fus)

Maintenance and Specifications

• 4.6L V8 engine

• Oil levels above the upper hole may cause engine damage. Some oil

must be removed from the engine by an authorized dealer.

7. Put the dipstick back in and ensure it is fully seated.

Adding engine oil

1. Check the engine oil. For instructions, refer to Checking the engine

oil in this chapter.

2. If the engine oil level is not within the normal range, add only certified

engine oil of the recommended viscosity. Remove the engine oil filler cap

and use a funnel to pour the engine oil into the opening.

3. Recheck the engine oil level. Make sure the oil level is not above the

upper hole on the engine oil level dipstick.

4. Install the dipstick and ensure it is fully seated.

5. Fully install the engine oil filler cap by turning the filler cap clockwise

until three clicks can be heard.

To avoid possible oil loss, DO NOT operate the vehicle with the

engine oil level dipstick and/or the engine oil filler cap removed.

358

2010 Explorer (exp)

Owners Guide, 2nd Printing

USA (fus)

Maintenance and Specifications

Engine oil and filter recommendations

4.0L V6 Engine

Look for this certification

trademark.

Use SAE 5W-30 engine oil

Only use oils “Certified For Gasoline Engines” by the American

Petroleum Institute (API). An oil with this trademark symbol conforms

to the current engine and emission system protection standards and fuel

economy requirements of the International Lubricant Standardization and

Approval Committee (ILSAC), comprised of U.S. and Japanese

automobile manufacturers.

To protect your engine and engine’s warranty, use Motorcraft௡ SAE

5W-30 or an equivalent SAE 5W-30 oil meeting Ford specification

WSS-M2C929-A. Refer to Maintenance product specifications and

capacities later in this section for more information.

Do not use supplemental engine oil additives, cleaners or other engine

treatments. They are unnecessary and could lead to engine damage that

is not covered by Ford warranty.

Change your engine oil according to the appropriate schedule listed in

the scheduled maintenance information.

Ford production and Motorcraft௡ replacement oil filters are designed for

added engine protection and long life. If a replacement oil filter is used

that does not meet Ford material and design specifications, start-up

engine noises or knock may be experienced.

It is recommended you use the appropriate Motorcraft௡ oil filter or

another with equivalent performance for your engine application.

359

2010 Explorer (exp)

Owners Guide, 2nd Printing

USA (fus)

Maintenance and Specifications

4.6L 3V V8 Engine

Look for this certification

trademark.

Use SAE 5W-20 engine oil

Only use oils “Certified For Gasoline Engines” by the American

Petroleum Institute (API). An oil with this trademark symbol conforms

to the current engine and emission system protection standards and fuel

economy requirements of the International Lubricant Standardization and

Approval Committee (ILSAC), comprised of U.S. and Japanese

automobile manufacturers.

To protect your engine and engine’s warranty, use Motorcraft௡ SAE

5W-20 or an equivalent SAE 5W-20 oil meeting Ford specification

WSS-M2C930-A. SAE 5W-20 oil provides optimum fuel economy and

durability performance meeting all requirements for your

vehicle’s engine. Refer to Maintenance product specifications and

capacities later in this section for more information.

Do not use supplemental engine oil additives, cleaners or other engine

treatments. They are unnecessary and could lead to engine damage that

is not covered by Ford warranty.

Change your engine oil according to the appropriate schedule listed in

the scheduled maintenance information.

Ford production and Motorcraft௡ replacement oil filters are designed for

added engine protection and long life. If a replacement oil filter is used

that does not meet Ford material and design specifications, start-up

engine noises or knock may be experienced.

It is recommended you use the appropriate Motorcraft௡ oil filter or

another with equivalent performance for your engine application.

360

2010 Explorer (exp)

Owners Guide, 2nd Printing

USA (fus)

Maintenance and Specifications

BATTERY

Your vehicle is equipped with a

Motorcraft௡ maintenance-free

battery which normally does not

require additional water during its

life of service.

If your battery has a cover/shield, make sure it is reinstalled

after the battery has been cleaned or replaced.

For longer, trouble-free operation, keep the top of the battery clean and

dry. Also, make certain the battery cables are always tightly fastened to

the battery terminals.

If you see any corrosion on the battery or terminals, remove the cables

from the terminals and clean with a wire brush. You can neutralize the

acid with a solution of baking soda and water.

It is recommended that the negative battery cable terminal be

disconnected from the battery if you plan to store your vehicle for an

extended period of time. This will minimize the discharge of your battery

during storage.

Note: Electrical or electronic accessories or components added to

the vehicle by the dealer or the owner may adversely affect

battery performance and durability.

WARNING: Batteries normally produce explosive gases which

can cause personal injury. Therefore, do not allow flames, sparks

or lighted substances to come near the battery. When working near the

battery, always shield your face and protect your eyes. Always provide

proper ventilation.

WARNING: When lifting a plastic-cased battery, excessive

pressure on the end walls could cause acid to flow through the

vent caps, resulting in personal injury and/or damage to the vehicle or

battery. Lift the battery with a battery carrier or with your hands on

opposite corners.

361

2010 Explorer (exp)

Owners Guide, 2nd Printing

USA (fus)

Maintenance and Specifications -> ENGINE OIL for Your Ford Explorer SUV Fifth Generation (2005-2011)

Related Topics

Maintenance and Specifications