2009-2016 Ford Fiesta 4 Door Starting and Stopping the Engine -> Engine Block Heater User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Starting and Stopping the Engine -> Engine Block Heater for Your Ford Fiesta 4 Door Sixth Generation (2009-2016)

Starting and Stopping the Engine  
1. Move the transmission selector lever  
The idle speed varies depending on certain  
factors. These include vehicle component  
and ambient temperatures as well as  
electrical and climate system demands.  
to position P or N.  
2. Start the engine.  
All Vehicles  
Failure to Start  
If the engine does not start within 10  
seconds, wait for a short period and try  
again.  
Vehicles with Manual Transmission  
If the engine does not crank when you fully  
depress the clutch pedal and turn the  
ignition key to position D:  
If the engine does not start after three  
attempts, wait 10 seconds and follow the  
flooded engine procedure.  
1. Fully depress the clutch and brake  
pedals.  
If you have difficulty starting the engine  
when the temperature is below -13°F  
(-25°C), press the accelerator pedal to the  
mid-way point of its travel and try again.  
2. Turn the key to position D until the  
engine has started.  
Flooded Engine  
SWITCHING OFF THE ENGINE  
Vehicles with Manual Transmission  
Vehicles With a Turbocharger  
WARNING  
1. Fully depress the clutch pedal.  
2. Fully depress the accelerator pedal and  
hold it there.  
Do not switch the engine off when it  
is running at high speed. If you do, the  
turbocharger will continue running  
after the engine oil pressure has dropped  
to zero. This will lead to premature  
turbocharger bearing wear.  
3. Start the engine.  
VehicleswithAutomaticTransmission  
1. Move the transmission selector lever  
to position P or N.  
Release the accelerator pedal. Wait until  
the engine has reached idle speed and then  
switch it off.  
2. Fully depress the accelerator pedal and  
hold it there.  
3. Start the engine.  
All Vehicles  
ENGINE BLOCK HEATER (If  
If the engine does not start, repeat the cold  
or hot engine procedure.  
Equipped)  
WARNINGS  
Engine Idle Speed after Starting  
Failure to follow engine block heater  
instructions could result in property  
damage or serious personal injury.  
The speed at which the engine idles  
immediately after starting minimizes  
vehicle emissions and maximizes cabin  
comfort and fuel economy.  
Do not use your heater with  
ungrounded electrical systems or  
two-pronged adapters. There is a risk  
of electrical shock.  
114  
Fiesta (CCT), enUSA, Second Printing  
Starting and Stopping the Engine  
Note: The heater is most effective when  
Make sure the system is unplugged and  
outdoor temperatures are below 0°F  
(-18°C).  
properly stowed before starting and  
driving your vehicle. Make sure the  
protective cover seals the prongs of the  
block heater cord plug when not in use.  
The heater acts as a starting aid by  
warming the engine coolant. This allows  
the climate control system to respond  
quickly. The equipment includes a heater  
element (installed in the engine block) and  
a wire harness. You can connect the  
system to a grounded 120-volt AC  
electrical source.  
Make sure the heater system is  
checked for proper operation before  
winter.  
Using the Engine Block Heater  
Make sure the receptacle terminals are  
clean and dry prior to use. Clean them with  
a dry cloth if necessary.  
We recommend that you do the following  
for a safe and correct operation:  
Use a 16-gauge outdoor extension cord  
that is product certified by  
The heater uses 0.4 to 1.0 kilowatt-hours  
of energy per hour of use. The system does  
not have a thermostat. It achieves  
maximum temperature after  
approximately three hours of operation.  
Using the heater longer than three hours  
does not improve system performance and  
unnecessarily uses electricity.  
Underwriters Laboratory (UL) or  
Canadian Standards Association  
(CSA). This extension cord must be  
suitable for use outdoors, in cold  
temperatures, and be clearly marked  
Suitable for Use with Outdoor  
Appliances. Do not use an indoor  
extension cord outdoors. This could  
result in an electric shock or become a  
fire hazard.  
Use as short an extension cord as  
possible.  
Do not use multiple extension cords.  
Make sure that when in operation, the  
extension cord plug and heater cord  
plug connections are free and clear of  
water. This could cause an electric  
shock or fire.  
Make sure your vehicle is parked in a  
clean area, clear of combustibles.  
Make sure the heater, heater cord and  
extension cord are firmly connected.  
Check for heat anywhere in the  
electrical hookup once the system has  
been operating for approximately 30  
minutes.  
115  
Fiesta (CCT), enUSA, Second Printing  

Related Topics

Popular Owner Manuals