2009-2016 Ford Fiesta 4 Door Starting and Stopping the Engine -> Keyless Starting User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Starting and Stopping the Engine -> Keyless Starting for Your Ford Fiesta 4 Door Sixth Generation (2009-2016)

Starting and Stopping the Engine  
GENERAL INFORMATION  
IGNITION SWITCH  
WARNINGS  
Extended idling at high engine  
speeds can produce very high  
temperatures in the engine and  
exhaust system, creating the risk of fire or  
other damage.  
Do not park, idle or drive your vehicle  
on dry grass or other dry ground  
E180794  
cover. The emission system heats up  
the engine compartment and exhaust  
system, creating the risk of fire.  
A (off) - The ignition is off.  
Note: When you switch the ignition off and  
leave your vehicle, do not leave your key in  
the ignition. This could cause your vehicle  
battery to lose charge.  
Do not start the engine in a closed  
garage or in other enclosed areas.  
Exhaust fumes can be toxic. Always  
open the garage door before you start the  
engine.  
Note: To switch the engine off when your  
vehicle is moving, move the transmission  
selector lever to position N. Use the brakes  
to bring the vehicle to a safe stop. After your  
vehicle has stopped, switch the engine off  
and move the transmission selector lever to  
position P. Turn the key to position A or B.  
If you smell exhaust fumes inside  
your vehicle, have your vehicle  
checked by an authorized dealer  
immediately. Do not drive your vehicle if  
you smell exhaust fumes.  
B (accessory) - Allows the electrical  
accessories such as the radio to operate  
while the engine is not running.  
If you disconnect the battery, your vehicle  
may exhibit some unusual driving  
characteristics for approximately 5 miles  
(8 kilometers) after you reconnect it. This  
isbecausetheenginemanagementsystem  
must realign itself with the engine. You can  
disregard any unusual driving  
Note: Do not leave the ignition key in this  
position for too long. This could cause your  
vehicle battery to lose charge.  
C (on) - All electrical circuits operational.  
Warning lamps and indicators illuminate.  
characteristics during this period.  
D (start) - cranks the engine. Release the  
key as soon as the engine starts.  
The powertrain control system meets all  
Canadian interference-causing equipment  
standard requirements regulating the  
impulse electrical field or radio noise.  
KEYLESS STARTING(If Equipped)  
WARNING  
When you start the engine, avoid pressing  
the accelerator pedal before and during  
operation. Only use the accelerator pedal  
when you have difficulty starting the  
engine.  
The system may not function if the  
key is close to metal objects or  
electronic devices such as cell  
phones.  
111  
Fiesta (CCT), enUSA, Second Printing  
Starting and Stopping the Engine  
Note: The ignition will automatically switch  
1. Move the transmission selector lever  
off when you leave your vehicle unattended.  
This is to prevent your vehicle battery  
running out of charge.  
to position P or N.  
2. Fully depress the brake pedal.  
3. Briefly press the button.  
Note: A valid key must be located inside  
your vehicle to switch the ignition on and  
start the engine.  
Failure to Start  
All Vehicles  
Ignition On  
The system will not function if:  
Press the START button once. It is located  
on the instrument panel near the steering  
wheel. All electrical circuits and  
accessories are operational and the  
warning lamps and indicators will  
illuminate.  
The key frequencies are jammed.  
The key battery has no charge.  
If you are unable to start your vehicle, do  
the following.  
E99666  
1. Hold the key next to the steering  
column exactly as shown.  
E142555  
2. With the key in this position you can  
use the button to switch the ignition on  
and start your engine.  
Starting with Manual  
Transmission  
Manual Transmission  
Note: Releasing the clutch pedal while the  
engine is starting will stop the engine  
cranking and return to ignition on.  
Note: Releasing the clutch pedal while the  
engine is starting will stop the engine  
cranking and return to ignition on. A  
message will be shown in the display.  
1. Fully depress the clutch pedal.  
2. Briefly press the button.  
If the engine does not crank when the  
clutch pedal has been fully depressed and  
the button is pressed:  
Starting with Automatic  
Transmission  
1. Fully depress both the clutch and brake  
pedals.  
Note: Releasing the brake pedal while the  
engine is starting will stop the engine  
cranking and return to ignition on.  
2. Press the button until the engine starts.  
112  
Fiesta (CCT), enUSA, Second Printing  

Related Topics

Popular Owner Manuals