Get Wheels and Tires -> Changing a Road Wheel Guide for Ford Mondeo 4 Door Fifth Generation (2014-2022)

Wheels and Tires

1. Press the right arrow button on the

CAUTION

The ground clearance of your vehicle

will be reduced. Take care when

parking next to a kerb.

steering wheel to enter the main menu.

2. Highlight Setup with the up and down

buttons and press the right arrow

button.

3. Highlight Tyre Pressures with the up

and down buttons and press the right

arrow button.

Note: Your vehicle may exhibit some

unusual driving characteristics.

Vehicle jack

WARNINGS

4. Highlight the desired setting and press

the OK button to confirm the setting.

5. Press the left arrow button to exit the

menu. Hold the left arrow button

pressed to return to the trip computer

display.

The vehicle jack supplied with your

vehicle should only be used when

changing a wheel in emergency

situations.

Before using the vehicle jack, check

that it is not damaged or deformed

and that the thread is lubricated and

free from foreign matter.

CHANGING A ROAD WHEEL

Locking lug nuts

You can obtain a replacement locking lug

nut key and replacement locking lug nuts

from your dealer using the reference

number certificate.

Never place anything between the

jack and the ground, or the jack and

the vehicle.

Note: Vehicles with a tire repair kit are not

equipped with a vehicle jack or a wheel

brace.

It is recommended to use a workshop type

hydraulic jack for changing between

summer and winter tires.

Vehicles with a temporary spare

wheel

WARNINGS

Do not exceed 80 km/h (50 mph).

Note: Use a jack with a minimum lifting

capacity of 1.5 tonnes and a lifting plate with

a minimum diameter of 80 millimeters (3.1

inches).

Drive the shortest possible distances.

Do not fit more than one spare wheel

on your vehicle at any one time.

Do not use snow chains on this type

of wheel.

Do not drive through an automatic

car wash.

Do not carry out any tire repairs on a

temporary spare wheel.

194

Mondeo (CA2) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 31-12-2014, CG3536en enGBR, Edition date: 11/2013

Wheels and Tires

Vehicles without tire repair kit

A

B

C

Jack

Wheel brace

Space for locking lug nut key

Your vehicle jack and wheel brace are

located in the spare wheel well.

Jacking and lifting points

CAUTION

Use only the specified jacking points.

If you use other positions, you may

damage the body, steering,

suspension, engine, braking system or the

fuel lines.

A

B

Emergency use only

Maintenance

195

Mondeo (CA2) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 31-12-2014, CG3536en enGBR, Edition date: 11/2013

Wheels and Tires

Vehicles with side skirts

Indentations in the sills A show the

location of the jacking points.

Assembling the wheel brace

Type one

WARNING

When returning the wheel brace

extension to its original position, take

care not to get your fingers caught.

Note: Make sure that the wheel brace is

fully extended.

Extend the wheel brace.

Type two

CAUTION

The screw-in towing eye has a

left-hand thread. Turn it

counterclockwise to install it. Make

sure that the towing eye is fully tightened.

The screw-in towing eye is located in the

spare wheel well.

196

Mondeo (CA2) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 31-12-2014, CG3536en enGBR, Edition date: 11/2013

Wheels and Tires

Removing a road wheel

WARNINGS

Park your vehicle in such a position

that neither the traffic nor you are

hindered or endangered.

Set up a warning triangle.

Make sure that the vehicle is on firm,

level ground with the wheels pointing

straight ahead.

Insert the screw-in towing eye into the

wheel brace.

Switch off the ignition and apply the

parking brake.

Removing the wheel trim

Type one

Insert the flat end of the wheel brace

between the rim and the trim and carefully

remove the trim.

If your vehicle has a manual

transmission, select first or reverse

gear. If it has an automatic

transmission, select park.

Have the passengers leave the

vehicle.

Type two

Secure the diagonally opposite

wheel with an appropriate block or

wheel chock.

Make sure that the arrows on

directional tires point in the direction

of rotation when the vehicle is

moving forwards. If you have to fit a spare

wheel with the arrows pointing in the

opposite direction, have the tire refitted in

the correct direction by a properly trained

technician.

Do not work underneath the vehicle

when it is supported only by a jack.

Make sure that the jack is vertical to

the jacking point and the base is flat

on the ground.

CAUTION

Do not lay alloy wheels face down on

1. Insert the wheel trim remover.

2. Remove the wheel trim.

the ground, this will damage the paint.

Note: Make sure that you pull the wheel

Note: The spare wheel is located under the

trim remover at right angles to the trim.

floor cover in the luggage compartment.

197

Mondeo (CA2) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 31-12-2014, CG3536en enGBR, Edition date: 11/2013

Wheels and Tires

Note: The lug nuts of alloy wheels and

spoked steel wheels can also be used for

the steel spare wheel for a short time

(maximum two weeks).

Note: Make sure the wheel and hub contact

surfaces are free from foreign matter.

Note: Make sure that the cones on the lug

nuts are against the wheel.

1. Install the wheel.

2. Install the lug nuts finger tight.

3. Install the locking lug nut key.

1. Install the locking lug nut key.

2. Slacken the lug nuts.

3. Jack up the vehicle until the tire is clear

of the ground.

4. Remove the lug nuts and the wheel.

Installing a road wheel

WARNINGS

Use only approved wheel and tire

sizes. Using other sizes could

4. Partially tighten the lug nuts in the

sequence shown.

5. Lower the vehicle and remove the jack.

damage the vehicle and will make

the National Type Approval invalid. See

Technical Specifications (page 199).

6. Fully tighten the lug nuts in the

sequence shown. See Technical

Specifications (page 199).

Do not fit run flat tires on vehicles

that were not originally fitted with

them. Please contact your dealer for

more details regarding compatibility.

7. Install the hub cap or cover using the

ball of your hand.

WARNING

Have the lug nuts checked for

tightness and the tire pressure

checked as soon as possible.

CAUTION

Do not install alloy wheels using lug

nuts designed for use with steel

wheels.

198

Mondeo (CA2) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 31-12-2014, CG3536en enGBR, Edition date: 11/2013

Wheels and Tires -> Changing a Road Wheel for Your Ford Mondeo 4 Door Fifth Generation (2014-2022)

Related Topics

Popular Owner Manuals

Latest Owner Manuals