Get Locks and Security -> Anti-theft system Guide for Ford Mustang 2 Door Fifth Generation (2005-2014)

Battery saver

The battery saver will shut off the interior lamps 10 minutes after the

ignition has been turned to the off position and a door is left open, and

in 30 minutes if the dome lamp control is left on and the ignition has

been turned to the off position. The battery saver will also shut off the

trunk lamps in 30 minutes if the trunk is left open.

SECURILOCK姞 PASSIVE ANTI-THEFT SYSTEM

SecuriLock威 passive anti-theft system is an engine immobilization

system. This system is designed to help prevent the engine from being

started unless a coded integrated keyhead transmitter (IKT)

programmed to your vehicle is used. The use of the wrong type of

coded key may lead to a “no-start” condition.

Your vehicle comes with two coded integrated keyhead transmitters;

additional coded IKTs may be purchased from your authorized dealer.

Standard SecuriLock威 keys without remote entry transmitter

functionality can also be purchased from your authorized dealer if

desired. The authorized dealer can program your spare IKTs to your

vehicle or you can program the IKTs yourself. Refer to Programming

spare keys for instructions on how to program the coded key.

Note: The SecuriLock威 passive anti-theft system is not compatible with

non-Ford aftermarket remote start systems. Use of these systems may

result in vehicle starting problems and a loss of security protection.

Note: Large metallic objects, electronic devices that are used to

purchase gasoline or similar items, or a second coded key on the same

key chain may cause vehicle starting issues. You need to prevent these

objects from touching the coded IKT while starting the engine. These

objects will not cause damage to the coded IKT, but may cause a

momentary issue if they are too close to the IKT when starting the

engine. If a problem occurs, turn the ignition off, remove all objects on

the key chain away from the coded IKT and restart the engine.

Note: Do not leave a duplicate coded key in the vehicle. Always

take your keys and lock all doors when leaving the vehicle.

Locks and Security

101

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

Anti-theft indicator

The anti-theft indicator is located in the instrument cluster.

• When the ignition is in the off

position, the indicator will flash

once every two seconds to

indicate the SecuriLock威 system

is functioning as a theft

deterrent.

• When the ignition is in the on position, the indicator will glow for

three seconds, then turn off to indicate normal system functionality.

If a problem occurs with the SecuriLock威 system, the indicator will flash

rapidly or glow steadily when the ignition is in the on position. If this

occurs, turn the ignition off then back to on to make sure there was no

electronic interference with the programmed key. If the vehicle doesn’t

start, try to start it with the 2nd programmed key and if successful

contact your authorized dealership for key replacement. If the indicator

still flashes rapidly or glows steadily, the vehicle will not start, contact

your authorized dealer as soon as possible for service.

Automatic arming

The vehicle is armed immediately after switching the ignition to the off

position.

The theft indicator will flash every

two seconds to act as a theft

deterrent when the vehicle is

armed.

Automatic disarming

Switching the ignition to the on position with a coded key disarms the

vehicle.

• The theft indicator will illuminate for three seconds and then go out.

• If the theft indicator stays on for an extended period of time or

flashes rapidly, contact your authorized dealer as soon as possible.

Replacement integrated keyhead transmitters (IKT) and coded keys

Note: Your vehicle comes equipped with two integrated keyhead

transmitters (IKTs). The IKT functions as both a programmed ignition

key that operates all the locks and starts the vehicle, as well as a remote

keyless entry transmitter. A maximum of eight coded keys can be

Locks and Security

102

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

programmed to your vehicle; only four of these eight keys can be IKTs

with remote entry functionality.

If your IKTs or standard SecuriLock威 coded keys are lost or stolen and

you don’t have an extra coded key, you will need to have your vehicle

towed to an authorized dealer. The key codes need to be erased from

your vehicle and new coded keys will need to be programmed.

Replacing coded keys can be very costly. Store an extra programmed key

away from the vehicle in a safe place to help prevent any

inconveniences. Please visit an authorized dealer to purchase additional

spare or replacement keys.

Programming spare keys

You can program your own integrated keyhead transmitters or standard

SecuriLock威 coded keys to your vehicle. This procedure will program

both the engine immobilizer keycode and the remote entry transmitter

portion of the IKT to your vehicle. Note: A maximum of eight coded

keys can be programmed to your vehicle; only four of these eight can be

IKTs with remote entry functionality.

Tips:

• Only use integrated keyhead transmitters (IKTs) or standard

SecuriLock威 keys.

• You must have two previously programmed coded keys (keys that

already operate your vehicle’s engine) and the new unprogrammed

key(s) readily accessible.

• If two previously programmed coded keys are not available, you must

take your vehicle to your authorized dealer to have the spare key(s)

programmed.

Please read and understand the

entire procedure before you begin.

1. Insert the first previously

programmed coded key into the

ignition.

2. Turn the ignition from the 1 (off)

position to the 3 (on) position. Keep

the ignition in the 3 (on) position

for at least three seconds, but no

more than 10 seconds.

3. Turn the ignition to the 1 (off) position and remove the first coded

key from the ignition.

Locks and Security

103

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

4. After three seconds but within 10 seconds of turning the ignition to

the 1 (off) position, insert the second previously coded key into the

ignition.

5. Turn the ignition from the 1 (off) position to the 3 (on) position. Keep

the ignition in the 3 (on) position for at least three seconds, but no more

than 10 seconds.

6. Turn the ignition to the 1 (off) position and remove the second

previously programmed coded key from the ignition.

7. After three seconds but within 20 seconds of turning the ignition to

the 1 (off) position and removing the previously programmed coded

key, insert the new unprogrammed key (new key/valet key) into the

ignition.

8. Turn the ignition from the 1 (off) position to the 3 (on) position. Keep

the ignition in the 3 (on) position for at least six seconds.

9. Remove the newly programmed coded key from the ignition.

If the key has been successfully programmed it will start the vehicle’s

engine and will operate the remote entry system (if the new key is an

integrated keyhead transmitter). The theft indicator light will illuminate

for three seconds and then go out to indicate successful programming.

If the key was not successfully programmed, it will not start your

vehicle’s engine and/or will not operate the remote entry features. The

theft indicator light may flash on and off. Wait 20 seconds and you may

repeat Steps 1 through 8. If failure repeats, bring your vehicle to your

authorized dealer to have the new key(s) programmed.

To program additional new unprogrammed key(s), wait 20 seconds and

then repeat this procedure from Step 1.

ACTIVE ANTI-THEFT SYSTEM (IF EQUIPPED)

The active anti-theft system is designed to warn you in the event of an

unauthorized entry to your vehicle and is also designed to help prevent

the unwanted towing of the vehicle.

When the vehicle is locked and armed, the active anti-theft system

monitors the following:

• Doors

• Hood

• Trunk

• Movement inside the vehicle

Locks and Security

104

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

• Change in vehicle inclination

Note: The active anti-theft system includes a motion detection system

which monitors the passenger cabin and a vehicle incline sensor which

detects changes in vehicle attitude.

The interior motion detection and vehicle incline sensing systems

will operate only when the vehicle is locked using the remote

keyless entry transmitter or when using the power door lock

control with the accompanying door open and all doors then

become closed. For convertible vehicles, the convertible top must

be in the fully closed and latched position for the interior motion

sensing system to arm. If you lock the vehicle using the key in the

driver door key cylinder, the system will monitor the doors,

trunk, and hood but the interior motion sensing and vehicle

incline sensing will not arm.

Do not arm the interior motion detection system if movement within the

vehicle is likely to occur. Additionally, do not arm the vehicle incline

sensing system when the vehicle is in transport.

For proper operation of the interior motion detection system, ensure all

windows are closed prior to arming the system. This will help prevent

accidental alarm activation due to external influences and ensure proper

interior motion detection. Additionally, the interior motion sensing

system will not arm if either door or the trunk is ajar.

If there is any potential perimeter anti-theft problem with your vehicle,

ensure ALL integrated keyhead transmitters are brought to the

authorized dealer to aid in troubleshooting.

Arming the system

When armed, the active anti-theft system is designed to notify you of an

unauthorized entry. When unauthorized entry or towing occurs, the

system will flash the turn signal lamps and interior lamps and will sound

the horn.

The system is ready to arm whenever the key is out of the ignition. Any

of the following actions will arm the alarm system:

• Press the

control on the remote entry transmitter portion of your

integrated keyhead transmitter.

• Lock all doors using the interior power lock switch while the driver or

passenger door is open and then becomes closed.

• Lock the driver door with the key in the key lock cylinder (this will

not however arm the interior motion or vehicle incline sensing

systems).

Locks and Security

105

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

There is a 20 second countdown when any of the above actions occur

before the vehicle becomes armed.

Each door, the hood or the trunk is armed individually, and if any are

open, they must be closed for the system to enter the 20 second

countdown.

The turn signal lamps will flash once when all doors, the hood and the

trunk are closed indicating the vehicle is locked and entering the

20 second countdown. If any closure is not properly closed the turn

signal lamps will not flash and that closure will not be armed.

Disarming the system

You can disarm the system by any of the following actions:

• Unlock the doors by using the remote entry transmitter portion of

your integrated keyhead transmitter.

• Turn ignition to the on position with a valid programmed SecuriLock威

key or integrated keyhead transmitter (IKT).

• Press the panic control on the remote entry transmitter portion of

your IKT. This will only shut off the horn and turn lamps when the

alarm is sounding. The alarm system will still be armed.

• Use a key in the driver’s door to unlock the vehicle.

Pressing the power door unlock control within the 20 second prearmed

mode will return the vehicle to a disarmed state.

Note: Unlocking the trunk inhibits the motion sensing system but the

system continues to monitor the doors, hood and vehicle incline. Once

the trunk becomes closed the motion sensing system will rearm.

Triggering the anti-theft system

The armed system will be triggered if:

• Any door, the hood or the trunk is opened without using the remote

entry transmitter portion of your IKT or key in driver door cylinder.

• The ignition is turned to the on position with an invalid

unprogrammed SecuriLock威 key or IKT.

• The vehicle is towed/inclined.

• Motion is detected in the interior passenger compartment.

Locks and Security

106

2010 05+ Mustang (197)

Owners Guide, 3rd Printing

USA (fus)

Locks and Security -> Anti-theft system for Your Ford Mustang 2 Door Fifth Generation (2005-2014)

Related Topics

Popular Owner Manuals

Latest Owner Manuals