2013-2015 Hyundai I30 4 Door Features of your vehicle -> Wipers and washers User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Features of your vehicle -> Wipers and washers for Your Hyundai I30 4 Door 2013-2015

Features of your vehicle  
WIPERS AND WASHERS  
Windshield wiper/washer  
A : Wiper speed control  
/MIST – Single wipe  
· O / OFF – Off  
Rear window wiper/washer  
(if equipped)  
Type A  
·
/
Type A  
· INT (---) / AUTO* – Intermittent wipe/  
Auto control wipe  
· 1 / LO – Normal wiper speed  
· 2 / HI – Fast wiper speed  
B : Intermittent or Auto control wipe  
time adjustment  
Type B  
Type B  
D
C : Wash with brief wipes  
D : Rear wiper/washer control  
·
·
– Spraying washer fluid  
/ ON – Normal wipe operation  
· O / OFF – Off  
·
– Wash with brief wipes  
Type C  
Type C  
*: if equipped  
OFD049900L/OFD049900C/OFD049900/OFD049065N/OFD049901C/OFD049901K  
4 65  
Features of your vehicle  
D200100AFD  
D200101AFD  
Auto control (if equipped)  
CAUTION  
Windshield wipers  
The rain sensor located on the upper end  
of the windshield glass senses the  
amount of rainfall and controls the wiping  
cycle for the proper interval. The more it  
rains, the faster the wiper operates.  
When the rain stops, the wiper stops. To  
vary the speed setting, turn the speed  
control knob (1).  
When the ignition switch is ON and  
the windshield wiper switch is  
placed in the AUTO mode, use cau-  
tion in the following situations to  
avoid any injury to the hands or  
other parts of the body:  
Operates as follows when the ignition  
switch is turned ON.  
/
/ MIST : For a single wiping  
cycle, move the lever to this  
(
/
/MIST)  
position  
and release it. The wipers  
will operate continuously if  
the lever is held in this posi-  
tion.  
• Do not touch the upper end of the  
windshield glass facing the rain  
sensor.  
If the ignition switch is turned ON when  
the wiper switch is set in AUTO mode, or  
the wiper switch is set in AUTO mode  
when the ignition switch is ON, or the  
speed control knob is turned upward  
when the wiper switch is in AUTO mode,  
the wiper will operate once to perform a  
self-check of the system. Set the wiper to  
O (OFF) position when the wiper is not in  
use.  
• Do not wipe the upper end of the  
windshield glass with a damp or  
wet cloth.  
O / OFF : Wiper is not in operation.  
INT / --- : Wiper operates intermittently at  
the same wiping intervals. Use  
this mode in a light rain or mist.  
To vary the speed setting, turn  
the speed control knob(1).  
• Do not put pressure on the wind-  
shield glass.  
1 / LO : Normal wiper speed  
2 / HI : Fast wiper speed  
NOTICE  
If there is heavy accumulation of snow  
or ice on the windshield, defrost the  
windshield for about 10 minutes, or  
until the snow and/or ice is removed  
before using the windshield wipers to  
ensure proper operation.  
4 66  
Features of your vehicle  
D200200AFD  
CAUTION  
CAUTION  
Windshield washers  
When washing the vehicle, set the  
wiper switch in the O (OFF) position  
to stop the auto wiper operation.  
• To prevent possible damage to  
the wipers or windshield, do not  
operate the wipers when the  
windshield is dry.  
In the O (OFF) position, pull the lever  
gently toward you to spray washer fluid  
on the windshield and to run the wipers  
1-3 cycles. Use this function when the  
windshield is dirty. The spray and wiper  
operation will continue until you release  
the lever. If the washer does not work,  
check the washer fluid level. If the fluid  
level is not sufficient, you will need to add  
appropriate non-abrasive windshield  
washer fluid to the washer reservoir.  
The wiper may operate and be dam-  
aged if the switch is set in the AUTO  
mode while washing the vehicle.  
• To prevent damage to the wiper  
blades, do not use gasoline,  
kerosene, paint thinner, or other  
solvents on or near them.  
Do not remove the sensor cover  
located on the upper end of the pas-  
senger side windshield glass.  
Damage to system parts could  
occur and may not be covered by  
your vehicle warranty.  
• To prevent damage to the wiper  
arms and other components, do  
not attempt to move the wipers  
manually.  
The reservoir filler neck is located in the  
front of the engine compartment on the  
passenger side.  
When starting the vehicle in winter,  
set the wiper switch in the O (OFF)  
position. Otherwise, wipers may  
operate and ice may damage the  
windshield wiper blades. Always  
remove all snow and ice and defrost  
the windshield properly prior to  
operating the windshield wipers.  
D200300AFD  
Rear window wiper and washer  
switch (if equipped)  
CAUTION  
To prevent possible damage to the  
washer pump, do not operate the  
washer when the fluid reservoir is  
empty.  
The rear window wiper and washer  
switch is located at the end of the wiper  
and washer switch lever. Turn the switch  
to desired position to operate the rear  
wiper and washer.  
- Spraying washer fluid and wiping  
/ ON - Normal wiper operation  
WARNING  
Do not use the washer in freezing  
temperatures without first warming  
the windshield with the defrosters;  
the washer solution could freeze on  
contact with the windshield and  
obscure your vision.  
O / OFF - Wiper is not in operation  
- Spraying washer fluid and wiping  
4 67  

Related Topics

Popular Owner Manuals