JD eng 6.QXP 3/12/2015 3:05 PM Page 22
What to do in an emergency
Distributing the sealant
Producing the tire inflation pres-
sure
1) After driving approximately 3 km (2
miles), stop at a suitable location.
- To reduce the inflation pres-
sure: Press the button 8 on the
compressor.
Immediately drive approximately 3 km
(2 miles) to evenly distribute the
sealant in the tire.
CAUTION
2) Connect the filling hose 2 of the
compressor (clip mounted side)
directly and then connect the filling
hose 2 (opposite side) to the tire
valve.
If the inflation pressure is not
maintained, drive the vehicle a
second time, refer to Distributing
the sealant. Then repeat steps 1
to 4.
CAUTION
Do not exceed a speed of 80
km/h (50 mph). If possible, do
not fall below a speed of 20
km/h (12 mph).
3) Connect between compressor and
the vehicle power outlet using the
cable and connectors.
Use of the TireMobilityKit may
be ineffectual for tire damage
larger than approximately 4 mm
(0.16 in).
While driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road.
4) Adjust the tire inflation pressure to
220 kPa (32 psi). With the ignition
switched on, proceed as follows.
We recommend that you contact
the nearest Kia A/S center, or a
workshop that works according
to Kia repair procedures with cor-
respondingly trained personnel if
the tire cannot be made roadwor-
thy with the TireMobilityKit.
- To increase the inflation pres-
sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
Call for road side service or tow-
ing.
WARNING
Do not let the compressor run for
more than 10 minutes, otherwise
the device will overheat and may
be damaged.
WARNING
The tire inflation pressure must
be at least 220 kPa (32 psi). If it is
not, do not continue driving. Call
for road side service or towing.
6 22
English 
