2013-2016 Mazda Cx-5 SUV Seat Belt Systems -> Seat Belt Precautions User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Seat Belt Systems -> Seat Belt Precautions for Your Mazda Cx-5 SUV First Generation (2013-2016)

Essential Safety Equipment  
Seat Belt Systems  
Seat Belt Precautions  
Seat belts help to decrease the possibility of severe injury during accidents and sudden  
stops. Mazda recommends that the driver and all passengers always wear seat belts.  
All of the seat belt retractors are designed to keep the lap/shoulder belts out of the way  
when not in use.  
The driver's seat belt has no provisions for child-restraint systems and has only an  
emergency locking mode. The driver may wear it comfortably, and it will lock during a  
collision.  
However, in some models (with automatic locking mode) the front passenger's seat and all  
rear lap/shoulder belt retractors operate in two modes: emergency locking mode, and for  
child-restraint systems, automatic locking mode. While we recommend you put all children  
in the rear seats, if you must use the front passenger seat for a child, slide the front  
passenger seat as far back as possible and make sure any child-restraint system is secured  
properly.  
WARNING  
Always wear your seat belt and make sure all occupants are properly restrained:  
Not wearing a seat belt is extremely dangerous. During a collision, occupants not  
wearing seat belts could hit someone or things inside the vehicle or even be thrown  
out of the vehicle. They could be seriously injured or even killed. In the same  
collision, occupants wearing seat belts would be much safer.  
Do not wear twisted seat belts:  
Twisted seat belts are dangerous. In a collision, the full width of the belt is not  
available to absorb the impact. This puts more force on the bones beneath the belt,  
which could cause serious injury or death. So, if your seat belt is twisted, you must  
straighten the seat belt to remove any twists and to allow the full width of the belt to  
be used.  
Never use one seat belt on more than one person at a time:  
Using one seat belt for more than one person at a time is dangerous. A seat belt  
used in this way cannot spread the impact forces properly and the two passengers  
could be crushed together and seriously injured or even killed. Never use one belt for  
more than one person at a time and always operate the vehicle with each occupant  
properly restrained.  
Do not operate a vehicle with a damaged seat belt:  
Using a damaged seat belt is dangerous. An accident could damage the belt  
webbing of the seat belt in use. A damaged seat belt cannot provide adequate  
protection in a collision. Have an Authorized Mazda Dealer inspect all seat belt  
systems in use during an accident before they are used again.  
2-17  
Essential Safety Equipment  
Seat Belt Systems  
Have your seat belts changed immediately if the pretensioner or load limiter has  
been expended:  
Always have an Authorized Mazda Dealer immediately inspect the front seat belt  
pretensioners and air bags after any collision. Like the air bags, the front seat belt  
pretensioners and load limiters will only function once and must be replaced after  
any collision that caused them to deploy. A seat belt with an expended pretensioner  
or load limiter is still better than wearing no seat belt at all; however, if the front  
seat belt pretensioners and load limiters are not replaced, the risk of injury in a  
collision will increase.  
Positioning the Shoulder Portion of the Seat Belt:  
Improper positioning of the shoulder portion of the seat belt is dangerous. Always  
make sure the shoulder portion of the seat belt is positioned across your shoulder  
and near your neck, but never under your arm, on your neck, or on your upper arm.  
Positioning the Lap Portion of the Seat Belt:  
The lap portion of the seat belt worn too high is dangerous. In a collision, this would  
concentrate the impact force directly on the abdominal area, causing serious injury.  
Wear the lap portion of the belt snugly and as low as possible.  
In a rollover crash, an unbelted person is significantly more likely to die than a  
person wearing a seat belt.  
CAUTION  
Belt retraction may become difficult if the belts and rings are soiled, so try to keep  
them clean. For more details about cleaning the seat belts, refer to Seat Belt  
Maintenance(page 6-70).  
Ring  
2-18  
Essential Safety Equipment  
Seat Belt Systems  
qPregnant Women and Persons with Serious Medical Conditions  
Pregnant women should always wear seat belts. Ask your doctor for specific  
recommendations.  
The lap belt should be worn SNUGLYAND AS LOWAS POSSIBLE OVER THE HIPS.  
The shoulder belt should be worn across your shoulder properly, but never across the  
stomach area.  
Persons with serious medical conditions also should wear seat belts. Check with your  
doctor for any special instructions regarding specific medical conditions.  
qEmergency Locking Mode  
When the seat belt is fastened, it will always be in the emergency locking mode.  
In the emergency locking mode, the belt remains comfortable on the occupant and the  
retractor will lock in position during a collision.  
If the belt is locked and cannot be pulled out, retract the belt once, and then try pulling it  
out slowly. If this fails, pull the belt strongly one time and loosen, then pull it out again  
slowly.  
(Seat Belt with Automatic Locking Mode)  
When the seat belt is fastened, it will always be in the emergency locking mode until it is  
switched to automatic locking mode by pulling it all the way out to its full length. If the  
belt feels tight and hinders comfortable movement while the vehicle is stopped or in  
motion, it may be in the automatic locking mode because the belt has been pulled too far  
out. To return the belt to the more comfortable emergency locking mode, wait until the  
vehicle has stopped in a safe, level area, retract the belt fully to convert it back to  
emergency locking mode and then extend it around you again.  
qAutomatic Locking Mode  
Always use the automatic locking mode to keep the child-restraint system from shifting to  
an unsafe position in the event of an accident. To enable seat belt automatic locking mode,  
pull it all the way out and connect it as instructed on the child-restraint system. It will  
retract down to the child-restraint system and stay locked on it. See the section on child  
restraint (page 2-26).  
2-19  

Related Topics

Popular Owner Manuals