2016-2026 Mazda Mx-5 SUV Interior Features -> Appendix User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Interior Features -> Appendix for Your Mazda Mx-5 SUV Fourth Generation (2016-2026)

Interior Features  
Appendix  
Do not spill any liquid on the audio  
system.  
Things You Need to Know  
WARNING  
Always adjust the audio while the vehicle is  
stopped:  
Do not adjust the audio control switches  
while driving the vehicle. Adjusting the  
audio while driving the vehicle is  
dangerous as it could distract your  
attention from the vehicle operation which  
could lead to a serious accident.  
Even if the audio control switches are  
equipped on the steering wheel, learn to  
use the switches without looking down at  
them so that you can keep your maximum  
attention on the road while driving the  
vehicle.  
Radio Reception  
AM characteristics  
AM signals bend around such things as  
buildings or mountains and bounce off the  
ionosphere.  
Therefore, they can reach longer distances  
than FM signals.  
Because of this, 2 stations may sometimes  
be picked up on the same frequency at the  
same time.  
Ionosphere  
CAUTION  
For the purposes of safe driving, adjust the  
audio volume to a level that allows you to  
hear sounds outside of the vehicle  
including car horns and particularly  
emergency vehicle sirens.  
Station 1  
Station 2  
NOTE  
To prevent the battery from being  
discharged, do not leave the audio  
system on for a long period of time when  
the engine is not running.  
If a cellular phone or CB radio is used  
in or near the vehicle, it could cause  
noise to occur from the audio system,  
however, this does not indicate that the  
system has been damaged.  
5-85  
Interior Features  
Appendix  
FM characteristics  
Multipath noise  
An FM broadcast range is usually about  
40―50 km (25―30 miles) from the  
source. Because of extra coding needed to  
break the sound into 2 channels, stereo FM  
has even less range than monaural  
(non-stereo) FM.  
Since FM signals can be reflected by  
obstructions, it is possible to receive both  
the direct signal and the reflected signal at  
the same time. This causes a slight delay  
in reception and may be heard as a broken  
sound or a distortion. This problem may  
also be encountered when in close  
FM Station  
proximity to the transmitter.  
40—50km  
(25—30 miles)  
Reflected wave  
Direct  
Signals from an FM transmitter are similar  
to beams of light because they do not bend  
around corners, but they do reflect. Unlike  
AM signals, FM signals cannot travel  
beyond the horizon. Therefore, FM  
Flutter/Skip noise  
Signals from an FM transmitter move in  
straight lines and become weak in valleys  
between tall buildings, mountains, and  
other obstacles. When a vehicle passes  
through such an area, the reception  
conditions may change suddenly, resulting  
in annoying noise.  
stations cannot be received at the great  
distances possible with AM reception.  
Ionosphere  
FM wave  
AM wave  
FM wave  
100—200 km (60—120 miles)  
Atmospheric conditions can also affect  
FM reception. High humidity will cause  
poor reception. However, cloudy days may  
provide better reception than clear days.  
5-86  
Interior Features  
Appendix  
Weak signal noise  
Station drift noise  
In suburban areas, broadcast signals  
become weak because of distance from the  
transmitter. Reception in such fringe areas  
is characterized by sound breakup.  
When a vehicle reaches the area of 2  
strong stations broadcasting at similar  
frequencies, the original station may be  
temporarily lost and the second station  
picked up. At this time there will be some  
noise from this disturbance.  
Station 2  
88.3 MHz  
Station 1  
88.1 MHz  
Strong signal noise  
This occurs very close to a transmitter  
tower. The broadcast signals are extremely  
strong, so the result is noise and sound  
breakup at the radio receiver.  
Operating Tips for MP3  
MP3 stands for MPEG Audio Layer 3,  
which is standardized voice compression  
*1  
established by the ISO working group  
(MPEG).  
Use of MP3 allows for audio data to be  
compressed to approximately a tenth of  
the source data size.  
This unit plays files with the extension  
(.mp3) as MP3 files.  
*
1 International Organization for  
Standardization  
CAUTION  
Do not use an audio ꢀle extension on ꢀles  
other than audio ꢀles. In addition, do not  
change the audio ꢀle extension. Otherwise,  
the unit will not recognize the ꢀle correctly  
resulting in noise or a malfunction.  
5-87  
Interior Features  
Appendix  
NOTE  
Operating Tips for WMA  
Supply of this product only conveys a  
license for private, non-commercial use  
and does not convey a license nor imply  
any right to use this product in any  
commercial (i.e. revenue-generating) real  
time broadcasting (terrestrial, satellite,  
cable and/or any other media),  
broadcasting/streaming via the Internet,  
intranets and/or other networks or in other  
electronic content distribution systems,  
such as pay-audio or audio-on-demand  
applications. An independent license for  
such use is required. For details, please  
*1  
WMA is short for Windows Media  
Audio and is the audio compression  
*1  
format used by Microsoft .  
Audio data can be created and stored at a  
higher compression ratio than MP3.  
This unit plays files with the extension  
(.wma) as WMA files.  
*
1 Windows Media and Microsoft are  
registered trademarks of Microsoft  
Corporation U.S. in the United States  
and other countries.  
CAUTION  
When naming an MP3 file, be sure to  
add an MP3 file extension (.mp3) after  
the file name.  
The number of characters which can be  
Do not use an audio ꢀle extension on ꢀles  
other than audio ꢀles. In addition, do not  
change the audio ꢀle extension. Otherwise,  
the unit will not recognize the ꢀle correctly  
resulting in noise or a malfunction.  
displayed is restricted.  
WMA files written under specifications  
other than the indicated specification  
may not play normally or files or folder  
names may not display correctly.  
The file extension may not be provided  
depending on the computer operating  
system, version, software, or settings. In  
this case, add the file extension “.wma”  
to the end of the file name, and then  
write it to the memory.  
5-88  
Interior Features  
Appendix  
Operating Tips for AAC  
Operating Tips for OGG  
AAC stands for Advanced Audio Coding,  
which is standardized voice compression  
established by the ISO working group  
(MPEG). Audio data can be created and  
stored at a higher compression ratio than  
MP3.  
OGG is the audio compression format for  
Xiph. Org Foundation.  
Audio data can be created and stored at a  
higher compression ratio than MP3.  
This unit plays files with the extension  
(.ogg) as OGG files.  
*1  
This unit plays files with the extensions  
(.aac/.m4a/.wav) as the AAC files.  
CAUTION  
CAUTION  
Do not use an audio ꢀle extension on ꢀles  
other than audio ꢀles. In addition, do not  
change the audio ꢀle extension. Otherwise,  
the unit will not recognize the ꢀle correctly  
resulting in noise or a malfunction.  
Do not use an audio ꢀle extension on ꢀles  
other than audio ꢀles. In addition, do not  
change the audio ꢀle extension. Otherwise,  
the unit will not recognize the ꢀle correctly  
resulting in noise or a malfunction.  
OGG files written under specifications  
other than the indicated specification  
may not play normally or files or folder  
names may not display correctly.  
AAC files written under specifications  
other than the indicated specification  
may not play normally or files or folder  
names may not display correctly.  
The file extension may not be provided  
depending on the computer operating  
system, version, software, or settings. In  
this case, add the file extension “.ogg”  
to the end of the file name, and then  
write it to the memory.  
The file extension may not be provided  
depending on the computer operating  
system, version, software, or settings. In  
this case, add the file extension “.aac”,  
“.m4a”, or “.wav” to the end of the file  
name, and then write it to the memory.  
*1 International Organization for  
Standardization  
5-89  
Interior Features  
Appendix  
(Vehicles without USB port indicated  
with  
If a device exceeds the maximum  
electric current value of 1,000 mA, it  
may not operate or recharge when  
connected.  
Operating Tips for USB device  
)
This unit plays audio files as follows:  
Extension  
.mp3  
Playback with this unit  
MP3  
.wma  
.aac  
WMA  
(Vehicles with USB port indicated with  
AAC  
.m4a  
)
If the current consumption of the  
connected device exceeds the following  
current value, it may not operate or  
recharge.  
.wav  
WAV  
OGG  
.ogg  
CAUTION  
Apple device is connected : 2,100 mA  
Device compatible with BC1.2 is  
Do not use an audio ꢀle extension on ꢀles  
other than audio ꢀles. In addition, do not  
change the audio ꢀle extension. Otherwise,  
the unit will not recognize the ꢀle correctly  
resulting in noise or a malfunction.  
connected : 1,500 mA  
Device other than the above is  
connected : 500 mA  
Do not pull out the USB device while in  
the USB mode (only pull it out while in  
FM/AM radio mode).  
The device will not operate if the data is  
password protected.  
NOTE  
Playback may not be possible depending  
on the type and condition of the USB  
flash memory even if the audio file  
complies with the standard.  
A copyright protected WMA/AAC file  
cannot be played in this unit.  
MP3/WMA/AAC/OGG files written under  
specifications other than the indicated  
specification may not play normally or  
files/folder names may not display  
correctly.  
If a file name in the USB memory is too  
long, it could cause operation problems  
such as not being able to playback the  
song.  
(Recommended: Within 80 characters)  
The order of the music data stored in the  
device may differ from the playback  
order.  
To prevent loss or damage of stored  
data, we recommend that you always  
back up your data.  
5-90  
Interior Features  
Appendix  
Agreements and disclaimers related  
to Apple CarPlay™  
Operating Tips for Android™  
Requires the Android Auto app on Google  
Play and an Android compatible  
smartphone running Android™ 5.0  
Lollipop or higher.  
This unit is compatible with Apple  
CarPlay™ which can operate an iPhone  
using the vehicle's audio device.  
®
CAUTION  
iPhone, Siri and Apple Music are  
registered trademarks of Apple Inc.  
Apple CarPlay is trademarks of Apple  
Inc.  
iOS is a trademark or registered  
trademark of Cisco in the U.S. and other  
countries and is used under license.  
For the purposes of safety, do not  
operate your Android™ Smartphone  
while driving.  
Disconnect the Android™ Smartphone  
when it is not in use. If the device is left in  
the cabin, it could be damaged or the  
battery may weaken due to the excessive  
temperature or humidity inside the  
cabin.  
May not be compatible depending on the  
model or OS version.  
CAUTION  
If the Android™ Smartphone battery has  
deteriorated, it may not recharge or play  
audio even if it is connected to this unit.  
Before use, carefully read the user  
instructions for the Android™  
For the purposes of safety, do not  
®
operate your iPhone while driving.  
®
Disconnect the iPhone when it is not in  
use. If the device is left in the cabin, it  
could be damaged or the battery may  
deteriorate due to the excessive  
temperature or humidity inside the  
cabin.  
Smartphone.  
NOTE  
To prevent loss or damage of stored data,  
we recommend that you always back up  
your data.  
®
If the iPhone battery has deteriorated, it  
may not recharge or play audio even if it  
Google, Android, Android Auto and  
other related marks are trademarks of  
Google LLC.  
is connected to this unit.  
Before use, carefully read the user  
®
instructions for the iPhone .  
NOTE  
To prevent loss or damage of stored data,  
we recommend that you always back up  
your data.  
5-91  

Related Topics

Popular Owner Manuals