Driving and parking 179
#
#
#
R
Point remote control 5 from a distance of
1 cm to 8 cm towards button 1, 2 or 3.
The vehicle as well as persons and objects
are located outside the range of movement
of the door.
Hold remote control 5 at the same angles
at various distances in front of the inside rear
view mirror. You should test every position
for at least 25 seconds before trying another
position.
On remote controls that transmit only for a
limited period, press button 6 on remote
control 5 again before transmission ends.
Press and hold button 6 of remote control
5 until one of the following signals appears:
#
Press the programming button on the door
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1, 2
or 3 repeatedly until the door closes.
When the door closes, programming is com‐
pleted.
R
Indicator lamp 4 lights up green contin‐
uously. Programming is complete.
#
#
R
Indicator lamp 4 flashes green. Pro‐
gramming was successful. Additionally,
synchronisation of the rolling code with
the door system must also be carried out.
#
Align the aerial line of the door opener unit
with the remote control.
#
#
% Support and additional information on pro‐
If indicator lamp 4 does not light up or flash
green: repeat the procedure.
Release all of the buttons.
gramming:
% Please also read the operating instructions
On the HomeLink® Hotline on (0) 08000
466 354 65 or +49 (0) 6838 907-277
R
for the door drive.
% The remote control for the door drive is not
included in the scope of delivery of the
garage door opener.
Troubleshooting when programming the
remote control
R
on the Internet at https://
#
Check if the transmitter frequency of remote
control 5 is supported.
Synchronising the rolling code
Requirements:
Opening or closing the garage door
Requirements:
#
Replace the batteries in remote control 5.
#
R
Hold remote control 5 at various angles
The door system uses a rolling code.
The vehicle must be within range of the
garage door or door drive.
R
The corresponding button is programmed to
from a distance of 1 cm to 8 cm front of the
inside rearview mirror. You should test every
position for at least 25 seconds before trying
another position.
operate the door.
R
#
Press and hold buttons 1, 2 or 3 until
the door opens or closes.