Seats and stowing -> Cup holder for Your Mercedes GLC Class SUV First Generation (2015-2021)

Seats and stowing 121  
Attaching the roof carrier  
Cup holder  
NOTE Damage to the panorama roof with  
power tilt/sliding panel caused by a non-  
approved roof rack  
*
Installing the cup holder in or removing it  
from the center console (automatic trans‐  
mission)  
&
WARNING Risk of injury if the maximum  
roof load is exceeded  
The panorama roof with power tilt/sliding  
panel may be damaged by the roof rack if  
you attempt to open it when using a roof  
rack that has not been tested and approved  
for Mercedes-Benz.  
When you load the roof, the center of gravity  
of the vehicle rises and the usual driving  
characteristics as well as the steering and  
braking characteristics change. During cor‐  
nering, the vehicle tilts more strongly and  
may react more sluggishly to steering move‐  
ments.  
If you exceed the maximum roof load, the  
driving characteristics, as well as the steer‐  
ing and braking characteristics, will be  
greatly impaired.  
&
WARNING ‑ Risk of accident or injury  
when using the cup holder while the  
vehicle is moving  
The cup holder cannot secure containers  
while the vehicle is moving.  
#
When a roof rack is installed, open the  
panorama roof with power tilt/sliding  
panel only if the roof rack has been tes‐  
ted and approved for Mercedes-Benz.  
If you use a cup holder while the vehicle is  
moving, the container may be flung around  
and liquids may be spilled. The vehicle occu‐  
pants may come into contact with the liquid  
and if it is hot, they could be scalded. You  
could be distracted from traffic conditions  
and you may lose control of the vehicle.  
In order to allow ventilation of the vehicle  
interior, you can raise the panorama roof  
with power tilt/sliding panel.  
#
Always comply with the maximum roof  
load and adjust your driving style.  
#
Secure the roof rack to the roof railing.  
Observe the manufacturer's installation  
instructions.  
#
Only use the cup holder when the vehi‐  
cle is stationary.  
#
You will find information on the maximum roof  
load in the "Technical data" section.  
#
Only use the cup holder for containers  
of the right size.  
#
Close the container, particularly if the  
liquid is hot.  
122 Seats and stowing  
Opening or closing the cup holders in the  
rear armrest  
NOTE Damage to the rear armrest due to  
body weight  
*
When folded out, the rear armrest can be  
damaged by body weight.  
#
Do not sit or support yourself on the  
rear seat armrest.  
#
#
To open: press cup holder 1 or 2.  
Cup holder 1 or 2 will extend automati‐  
cally.  
To close: push cup holder 1 or 2 back  
until it engages.  
NOTE Damage to the cup holder  
*
When the rear armrest is folded back the cup  
holder could become damaged.  
#
Only fold the rear armrest back when  
the cup holder is closed.  
#
To remove: slide catch 2 forwards and pull  
out cup holder 1.  
#
To install: insert cup holder 1 and slide  
back catch 2.  
% The cup holder rubber mat can be removed  
for cleaning, e.g. using clean, lukewarm  
water.