INSTRUCTIONS BEFORE USING THE VEHICLE
Charging Operation
Note: If at any time during the charging process you
should want to check the state of charge, please switch
the vehicle power system to the 'ON' position. the high
voltage battery state of charge will be displayed in the
Use an AC charging pile
IMPORTANT
message centre in the instrument pack.
Please ensure that only charge points that meet
IEC61851 and IEC 62196 are used to connect to your
vehicle.
Residential Charging
To use the charging function, follow the instructions below:
1
After the Start switch is turned off, close all doors.
Using an AC charging device:
2
Open the charging port door and the charging port
cover.
1
After the Start switch is turned off, close all doors.
2
Open the charging port door and the charging port
cover.
3
4
5
Connect the handle of the slow charging connector to
the slow charging port on the vehicle body.
3
4
Plug in the charging connector. Lock the vehicle.
Connect the slow charging connector to the civil
electricity supply. Lock the vehicle.
On completion of the charge, unlock the vehicle and
then disconnect the charging connector from the
vehicle.
On completion of the charge, shut off the power,
unlock the vehicle, disconnect the connector from the
vehicle and then the socket at the power supply side.
5
Make sure there is no debris or foreign matter in the
charging port and then close the charging port cover
and the charging port door in sequence.
6
Make sure there is no debris or foreign matter in the
charging port and then close the charging port cover
and the charging port door in sequence.
38
English 
