Get Sunroof * Guide for Mg HS SUV Second Generation (2024-2026)

BRIEF INTRODUCTION TO VEHICLE FUNCTIONS

Sunroof *

If there are children in the vehicle, ALWAYS

turn off the START/STOP Switch when

temporarily leaving the vehicle - to prevent

children from accidentally operating the

sunroof and causing danger.

The sunroof assembly consists of two pieces of glass of

which the front glass can be opened by sliding or tilting, the

rear one is ﬁxed-type and cannot be opened. The sunroof

also consists of a sunshade which can be opened by sliding.

2

•

Do not open the sunroof in poor weather conditions;

Try to avoid opening the sunroof at high speed;

Open the sunroof only after the water on the sunroof

glass has been cleared, otherwise water may fall into the

interior of the vehicle;

Instructions for Use

DO NOT allow passengers to lean out of an

open sunroof whilst the vehicle is in motion.

Injuries may occur from objects such as tree

branches.

•

Clean the glass with cleaning solvents such as alcohol;

Upon completion of the sunroof operation, release the

switch in time. Otherwise it may result in a fault;

To ensure the sunroof functions normally, please clean

it frequently and go to a Local Authorised Repairer for

service as required.

Safety of the vehicle occupants must be

observed at all times. DO NOT allow limbs

to be placed in the moving path of the

sunroof at any time, injury may occur.

•

Please operate the sunroof correctly to

avoid danger. The driver shall instruct the

occupants on the use of the sunroof and

safety precautions.

85

BRIEF INTRODUCTION TO VEHICLE FUNCTIONS

Sunroof Operation

Sunroof Glass Operation

Tilt Open

When the Start switch is in the yellow light state and green

light state, the sunroof can be operated.

Push up the sunroof glass switch to the 1st position （ 1

）and hold, the sunroof will be opened manually in a tilt

manner. Sunroof movement can be stopped at any time by

releasing the switch.

The sunroof switch is located on the ceiling above the

front windscreen. The opening methods of sunroof can be

identiﬁed according to the switch symbols. Switch 1 will

be used to operate the sunroof sunshade and switch 2 will

be used to operate the sunroof glass.

Push up the glass switch to the 2nd position （ 2 ） and

then release, the sunroof will be fully opened automatically.

Tilt Close

Pull down the sunroof glass switch to the 1st position （ 3

） and hold, the sunroof will be manually closed. Sunroof

86

BRIEF INTRODUCTION TO VEHICLE FUNCTIONS

movement can be stopped at any time by releasing the

Slide Close

switch.

Push the sunroof glass switch forward to the 1st position （

1 ）and hold, the sunroof will be manually closed. Sunroof

movement can be stopped at any time by releasing the

switch.

Pull down the glass switch to the 2nd position （ 4 ）and

then release, the sunroof will be fully closed automatically.

2

Slide Open

Push the glass switch forward with excessive force to the

2nd position（ 2 ） and then release, the sunroof will be

closed to the end automatically. Sunroof movement can

be stopped at any time by pushing the switch frontwards

again.

Note: Because the sunroof glass motor is steplessly

regulated, in order to prevent the glass from not

being closed completely due to the error of visual

perception, it is recommended to use the second gear

for automatic closing when the sunroof glass needs to

be closed completely.

Push the sunroof glass switch backward to the 1st position (

3 ) and hold, the sunroof will be manually opened by sliding.

Sunroof movement can be stopped at any time by releasing

the switch.

Push the glass switch backward to the 2nd position （ 4

） and then release, the sunroof will be opened to the end

automatically. Sunroof movement can be stopped at any

time by pushing the switch backwards again.

87

BRIEF INTRODUCTION TO VEHICLE FUNCTIONS

Sunroof Sunshade Operation

stop the movement of the sunshade at any time by releasing

the switch.

Push the sunshade switch forward to the 2nd position （

2 ） and then release, the sunshade will be fully closed

automatically. You can stop the movement of the sunshade

at any time by pushing the switch forward again.

Note: If you park the vehicle for a long period of time,

it is recommended to close the sunshade; if possible,

park the vehicle into garage to prevent the in-car

temperature from rising due to long-time exposure,

without damaging the interior.

Open

Push the sunshade switch backward to the 1st position （

3 ）and hold, the sunshade will be manually opened by

sliding. You can stop the movement of the sunshade at any

time by releasing the switch.

'Anti-pinch' Function

During the close operation, the sunroof glass and sunshade

will stop closing and open automatically when the closing

resistance is increasing due to an obstacle, extreme

weather (i.e, temperature below - 20 ℃) or other causes,

so as to reduce the impact on the obstacle and protect

the sunroof movement mechanism.

Push the sunshade switch backward to the 2nd position

（ 4 ） and then release, the sunshade will be opened to

the end automatically. You can stop the movement of the

sunshade at any time by pushing the switch backward again.

Force Closing of the Sunroof Glass

Close

To forcibly close the sunroof glass n a situation for example,

were the sunroof has reopened due to the activation of the

Push the sunshade switch forward to the 1st position （ 1

）and hold, the sunshade will be manually closed. You can

88

BRIEF INTRODUCTION TO VEHICLE FUNCTIONS

anti-pinch function; slide the glass switch forward to the

Glass initialisation: fully close the glass, push the sunroof

glass switch forward to the 2nd position（ 2 ） and hold

for about 10 seconds, the glass will automatically slide open

for a distance during which the switch shall be continuously

operated to the 2nd position（ 2 ） until the sunroof has

been fully closed.

1st position within 5 seconds and hold it until the sunroof

glass is fully closed. Please note that the anti-pinch function

is not available when closing the sunroof glass.

2

Force Closing of the Sunshade

To forcibly close the sunshade in a situation for example,

where the sunshade has reopened due to the activation of

the anti-pinch function; slide the sunshade switch forward

to the 1st position within 5 seconds and hold it until the

sunshade is fully closed. Please note that the anti-pinch

function is not available when closing the sunshade.

Sunshade initialisation: fully close the sunshade, push the

sunshade switch forward to the 2nd position and hold

for about 10 seconds, the sunshade will automatically

slide open for a distance and then close, during the entire

process, the switch must be held in the 2nd position.

Thermal Protection

Linkage between Sunshade and Sunroof Glass

To prevent the sunroof glass motor and sunshade motor

from damage due to overheating, they are provided with a

thermal protection function.

To prevent the sunshade from being exposed, the sunshade

will move together when the sunroof glass is opened. To

close the sunshade, please close the sunroof glass ﬁrst.

When the heat protection is enabled, the sunroof can only

be closed and does not respond to other operations. After

the motor has cooled down and has exited the thermal

protection state, the sunroof can be operated as normal.

Unless the thermal protection function operates again.

Sunroof Initialisation

peration of the sunroof will be affected in the event of a

power failure when the sunroof glass or the sunshade is

in motion. It will therefore be necessary to initialise the

sunroof and/or the sunshade after powering on the vehicle.

89

Sunroof * for Your Mg HS SUV Second Generation (2024-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals