BRIEF INTRODUCTION TO VEHICLE FUNCTIONS
anti-pinch function; slide the glass switch forward to the
Glass initialisation: fully close the glass, push the sunroof
glass switch forward to the 2nd position（ 2 ） and hold
for about 10 seconds, the glass will automatically slide open
for a distance during which the switch shall be continuously
operated to the 2nd position（ 2 ） until the sunroof has
been fully closed.
1st position within 5 seconds and hold it until the sunroof
glass is fully closed. Please note that the anti-pinch function
is not available when closing the sunroof glass.
2
Force Closing of the Sunshade
To forcibly close the sunshade in a situation for example,
where the sunshade has reopened due to the activation of
the anti-pinch function; slide the sunshade switch forward
to the 1st position within 5 seconds and hold it until the
sunshade is fully closed. Please note that the anti-pinch
function is not available when closing the sunshade.
Sunshade initialisation: fully close the sunshade, push the
sunshade switch forward to the 2nd position and hold
for about 10 seconds, the sunshade will automatically
slide open for a distance and then close, during the entire
process, the switch must be held in the 2nd position.
Thermal Protection
Linkage between Sunshade and Sunroof Glass
To prevent the sunroof glass motor and sunshade motor
from damage due to overheating, they are provided with a
thermal protection function.
To prevent the sunshade from being exposed, the sunshade
will move together when the sunroof glass is opened. To
close the sunshade, please close the sunroof glass first.
When the heat protection is enabled, the sunroof can only
be closed and does not respond to other operations. After
the motor has cooled down and has exited the thermal
protection state, the sunroof can be operated as normal.
Unless the thermal protection function operates again.
Sunroof Initialisation
peration of the sunroof will be affected in the event of a
power failure when the sunroof glass or the sunshade is
in motion. It will therefore be necessary to initialise the
sunroof and/or the sunshade after powering on the vehicle.
89
English 
