2010-2017 Nissan Leaf 4 Door Charging -> How to normal charge User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Charging -> How to normal charge for Your Nissan Leaf 4 Door First Generation (2010-2017)

• Check by using the Li-ion battery available  
charge gauge on the meter when the power  
switch is placed in the ON position. See “Li-ion  
battery available charge gauge” in the “Instru-  
ments and controls” section and “Li-ion battery  
low charge warning” in the “Instruments and  
controls” section.  
HOW TO NORMAL CHARGE  
•
•
Be sure to follow the precautions for  
using the charger that can be installed  
in your home. Failing to do so could  
result in serious injury or death.  
WARNING  
•
If you use any medical electric devices,  
such as an implantable cardiac pace-  
maker or an implantable cardiovascu-  
lar defibrillator, check with the electric  
medical device manufacturer concern-  
ing the effects that charging may have  
on implanted devices before starting  
the charge operation. Charging may  
affect the operation.  
CAUTION  
• Check by using the charging status indicator  
light. See “Charging status indicator lights” in  
this section.  
Do not use any charging equipment  
that is not compatible with the LEAF.  
Doing so could prevent the Li-ion bat-  
tery from charging properly or could  
result in damage to the vehicle or Li-  
ion battery.  
NOTE:  
• During the charge operation, charge con-  
tinues when the power switch is placed in  
the ON position.  
•
If you have an implantable cardiac  
pacemaker or an implantable cardio-  
vascular defibrillator, while the Li-ion  
battery is charging:  
• Normal charge uses the charging device (AC  
220 - 240 volt, 20A) that can be installed in your  
home to charge the Li-ion battery.  
• The Li-ion battery cannot be charged if the  
quick charge connector and the normal  
charge connector are connected at the  
same time. If another charge connector is  
connected mid-charge, charging will stop.  
– Do not stay inside the vehicle.  
– Do not go inside the vehicle, for ex-  
ample to remove or place an item in  
the passenger compartment.  
– Do not open the rear hatch, for ex-  
ample to remove or place an item in  
the cargo area.  
Charging may affect the operation of  
electric medical device and result in  
serious personal injury or death.  
• Immediate charge, charging timer and remote  
charge (models with navigation system) can be  
performed in the normal charge mode. See  
“Charging methods”.  
• For safety reasons, it is not possible to  
switch to the READY to drive position  
while a charge connector is connected.  
• The Genuine NISSAN charging equipment  
communicates with the vehicle before Li-ion  
battery charging starts. If this communication  
does not occur because other equipment is  
used, the Li-ion battery will not charge.  
• During charging, it is possible that the  
radio may be inaudible due to noise by the  
electromagnetic wave.  
Charging CH-9  
• NISSAN recommends that you connect the  
normal charge cable when getting out of the  
vehicle, even if it is not going to be used. By  
doing this, you can get the most out of the  
remote climate control (models with navigation  
system) and Climate Ctrl. Timer functions the  
next time you use the vehicle.  
To start normal charge:  
1. Push the P (Park) position switch to place the  
vehicle in the P (Park) position and apply the  
parking brake.  
2. When charging the Li-ion battery, place the  
power switch in the OFF position. When the  
power switch is in the ON position, the Li-ion  
battery will not start charging.  
4. Connect the charge connector to the charge  
port. If it is connected normally, a beep will  
sound once.  
To stop normal charge:  
1. Ensure that the charge connector lock is not  
engaged. For more information, see “Charge  
connector lock switch” in this section.  
3. Open the charge port lid and charge port cap.  
See “Charge port lid” and “Charge port cap”  
in the “Pre-driving checks and adjustments”  
section.  
5. If charging has started or if the battery is  
waiting for charging timer, a beep will sound  
twice and the charging status indicator light  
display will change. See “Charging status in-  
dicator light”.  
2. Press the button on the charge connector,  
release the lock and remove the charge con-  
nector from the charge port and properly  
store it.  
3. After closing the charge port cap on the  
charge port, close the charge port lid.  
CH-10 Charging  

Related Topics

Popular Owner Manuals