IF THE LI-ION BATTERY BECOMES
COMPLETELY DISCHARGED
B
If the 12-volt battery is discharged, the
power switch cannot be moved from the
OFF position. Connect the jumper cables
B
9. While the booster vehicle
engine is run-
If the power limitation indicator light
illumi-
᭺
ning, place the EV system in the READY to
drive position.
nates, the traction motor output is limited result-
ing in reduced vehicle speed. Stop the vehicle in
a safe location before the Li-ion battery becomes
completely discharged and no power is available
to drive the vehicle. Contact Roadside assis-
tance; see your NISSAN Warranty Information
Booklet.
to the booster vehicle
before pushing
᭺
CAUTION
the power switch.
If the system does not start right away,
push the power switch to the OFF posi-
tion and wait 10 seconds before trying
again.
3. Push the P (Park)position switch to place the
vehicle in the P (Park) position.
4. Switch off all unnecessary electrical systems
(headlights, heater, air conditioner, etc.).
If possible, place the power switch in the OFF
position while waiting for assistance to prevent
discharging the 12-volt battery.
10. After starting your EV system, carefully dis-
connect the negative cable and then the
5. Place the power switch in the OFF position.
6. Remove the vent caps on the 12-volt battery
(if so equipped). Cover the battery with a
firmly wrung out moist cloth to reduce the
hazard of an explosion.
4
3
2
1
positive cable (
) and
᭺ → ᭺ → ᭺ → ᭺
keep the READY to drive position over 20
minutes to charge the 12-volt battery.
NOTE:
If the Li-ion battery becomes completely
discharged:
11. Replace the vent caps (if so equipped). Be
sure to dispose of the cloth used to cover
the vent holes because it may be contami-
nated with corrosive acid.
7. Connect jumper cables in the sequence as
• The vehicle is automatically placed in the
ON position and it will not be possible to
switch to the READY position.
1
2
3
4
᭺ → ᭺ → ᭺ → ᭺
illustrated (
).
CAUTION
12. If necessary, connect the vehicle to a charg-
ing station or EVSE (Electric Vehicle Supply
Equipment) to charge the Li-ion battery.
(See “Charge” section.) The vehicle can not
be driven until the Li-ion battery is charged.
• The vehicle is automatically switched to
the N (Neutral) position and it will not be
possible to drive the vehicle.
Always connect positive (+) to positive
(+) and negative (−) to body ground (for
example, as illustrated), not to the 12-
volt battery.
• Make sure the jumper cables do not
touch moving parts in the motor com-
partment and that the cable clamps do
not contact any other metal.
•
WARNING
If the vehicle is in the N (Neutral) position
and the Li-ion battery and the 12-volt
battery become completely discharged,
the vehicle can not be placed in the P
NOTE:
If it is not possible to turn the system ON by
following this procedure, contact a NISSAN
certified LEAF dealer immediately.
B
8. Start the engine of the booster vehicle
.
᭺
In case of emergency 6-11
English 
