2017-2023 Nissan Micra 4 Door Instruments and controls -> Headlight and turn signal switch User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Instruments and controls -> Headlight and turn signal switch for Your Nissan Micra 4 Door Fifth Generation (2017-2023)

REAR WINDOW AND OUTSIDE  
MIRROR (if so equipped)  
DEFROSTER SWITCH  
HEADLIGHT AND TURN SIGNAL  
SWITCH  
∙ Pre-mix windshield-washer fluid con-  
centrates with water to the manufac-  
turer’s recommended levels before  
pouring the fluid into the windshield-  
washer fluid reservoir. Do not use the  
windshield-washer fluid reservoir to  
mix the windshield-washer fluid con-  
centrate and water.  
LIC2116  
LIC3237  
To defrost the rear window glass and out-  
side mirrors (if so equipped), start the en-  
gine and push the rear window defroster  
switch on. The rear window defroster indi-  
cator light on the switch comes on. Push  
the switch again to turn the defroster off.  
HEADLIGHT CONTROL SWITCH  
Lighting  
1
Rotate the switch to the  
position,  
and the front parking, tail, license plate,  
and instrument panel lights will come  
on.  
The rear window defroster automatically  
turns off after approximately 15 minutes.  
2
Rotate the switch to the  
position,  
and the headlights will come on and all  
the other lights remain on.  
CAUTION  
When cleaning the inner side of the rear  
window, be careful not to scratch or  
damage the rear window defroster.  
2-18 Instruments and controls  
Battery saver system  
CAUTION  
If the ignition switch is placed in the OFF  
position while the headlight switch is in  
Use the headlights with the engine run-  
ning to avoid discharging the vehicle  
battery.  
the  
or  
position, the headlights  
will turn off after a period of time.  
CAUTION  
Even though the battery saver feature  
automatically turns off the headlights  
after a period of time, you should turn  
the headlight switch to the OFF position  
when the engine is not running to avoid  
discharging the vehicle battery.  
LIC3245  
DAYTIME RUNNING LIGHTS (DRL)  
SYSTEM  
Headlight beam select  
1
To select the high beam function, en-  
gage the low beams, then push the  
lever forward. The high beam lights  
The headlights automatically illuminate at a  
reduced intensity when the engine is started  
with the parking brake released. The DRL  
system operates with the headlight switch in  
the OFF position. Turn the headlight switch  
come on and the  
indicator light  
illuminates (blue). For additional infor-  
mation, refer to “Headlight control  
switch” in this section.  
to the  
or  
position for full illumina-  
tion when driving at night.  
2
Pull the lever back to return to the low  
beams.  
If the parking brake is applied before the  
engine is started, the DRL system does not  
illuminate. The DRL system illuminates  
when the parking brake is released. The  
DRL system will remain on until the ignition  
switch is placed in the OFF position.  
3
Pulling and releasing the lever flashes  
the headlight high beams on and off.  
The low beams need not be on for this  
function.  
Instruments and controls 2-19  
WARNING  
When the DRL system is active, tail  
lights on your vehicle are not on. It is  
necessary at dusk to turn on your head-  
lights. Failure to do so could cause an  
accident injuring yourself and others.  
LIC3430  
LIC3254  
INSTRUMENT BRIGHTNESS  
CONTROL  
The instrument brightness control oper-  
ates when the headlight control switch is in  
TURN SIGNAL SWITCH  
Turn signal  
1
Move the lever up or down to signal the  
turning direction. When the turn is  
completed, the turn signal cancels au-  
tomatically.  
the  
or  
position.  
A
Push the control  
to adjust the bright-  
ness of instrument panel lights when driv-  
ing at night.  
When the ignition is on and the knob is  
pushed, the illumination decreases. The  
brightness will return to the maximum  
level when the brightness is at its minimum  
and the knob is pushed.  
2-20 Instruments and controls  
HORN  
NOTE:  
In case of a turn signal light malfunction,  
the turn signal indicator will flash at a  
higher frequency when the turn signal is  
activated.  
Lane change signal  
2
Move the lever up or down until the  
turn signal begins to flash, but the lever  
does not latch, to signal a lane change.  
Hold the lever until the lane change is  
completed.  
Move the lever up or down until the  
turn signal begins to flash, but the lever  
does not latch, and release the lever.  
The turn signal will automatically flash  
three times.  
LIC3262  
LIC2419  
To sound the horn, push near the horn icon  
on the steering wheel.  
FRONT FOG LIGHTS (if so  
equipped)  
To turn the front fog lights on, rotate the  
headlight switch to the or posi-  
tion, then rotate the fog light switch to  
the position.  
To turn them off, rotate the fog light switch  
to the OFF position.  
WARNING  
Choose the appropriate method to signal  
a lane change based on road and traffic  
conditions.  
Do not disassemble the horn. Doing so  
could affect proper operation of the  
supplemental front air bag system.  
Tampering with the supplemental front  
air bag system may result in serious  
personal injury.  
Instruments and controls 2-21  

Related Topics

Popular Owner Manuals