COMPASS DISPLAY  
					•
					In places where the terrestrial magne-  
					tism is disturbed, the correction of the  
					direction starts automatically, extin-  
					guishing the direction bar. If turn is  
					made one ortwo times, the correction is  
					complete and the direction bar comes  
					back on.  
					Zone variation chart  
					push the ON/OFF switch when the ignition  
					switch is in the ACC or ON position. The  
					direction will be displayed.  
					Zone variation change procedure  
					The difference between magnetic north and  
					geographical north is known as variance. In  
					some areas, this difference can sometimes be  
					great enough to cause false compass readings.  
					Follow these instructions to set the variance for  
					your particular location if this happens:  
					Correction functions of the compass  
					display  
					The compass display is equipped with automatic  
					correction function. If the direction is not shown  
					correctly, carry out manual correction procedure  
					set out below.  
					1. Establish your location on the zone map.  
					Record your zone number.  
					Manual correction procedure:  
					2. Push in the ON/OFF switch for about 5  
					seconds until the current zone entry number  
					is displayed.  
					1. Push the ON/OFF switch for about 10 sec-  
					onds. The direction bar starts blinking.  
					2. Drive the vehicle slowly in an open and safe  
					area. The initial correction is completed while  
					turning one or two turns.  
					3. Push the ON/OFF switch repeatedly until the  
					new zone entry number is displayed.  
					Once the desired zone number is displayed,  
					stop pushing the ON/OFF switch and the dis-  
					play will show compass direction within a few  
					seconds.  
					In places where the terrestrial magnetism is  
					extremely disturbed, the initial correction proce-  
					dure may start automatically.  
					•
					If a magnet is put close to the compass  
					or the vehicle is driven where the terres-  
					trial magnetism is disturbed, the com-  
					pass display may not indicate the cor-  
					rect direction.  
					SIC0971  
					Instruments and controls 2-1 5  
					2-1-4 Instruments and controls