Theft warning system operation:
System operation
How to activate system:
Security indicator light
The warning system will give the following
alarm:
1. Close all windows and push the ignition
.
.
.
The hazard indicator blinks and the horn
sounds intermittently for about 30 sec-
onds. (except for Mexico)
The headlights blink and the horn sounds
intermittently for about 50 seconds. (for
Mexico)
The alarm automatically turns off after
approximately 30 or 50 seconds. However,
the alarm reactivates if the vehicle is
tampered with again.
switch to the “OFF” position.
The system can be activated even if the
windows are open.
2. Carry the Intelligent Key with you and get
out of the vehicle.
3. Make sure the hood is closed. Close and
lock all doors with the door handle request
switch, “LOCK”
button on the Intelli-
SIC2045
gent Key, power door lock switch or the
mechanical key.
The alarm is activated by:
The security indicator light is located in the
meter panel. It indicates the status of NATS.
The light operates whenever the ignition
switch is in the “LOCK”, “ACC” or “OFF” position.
The security indicator light indicates that the
security systems on the vehicle are operational.
If NATS is malfunctioning, this light will remain
on while the ignition switch is in the “ON”
position.
If the light remains on and/or the engine
does not start, contact a NISSAN dealer for
NATS service as soon as possible. Be sure to
bring all Intelligent Keys that you have when
visiting a NISSAN dealer for service.
4. Confirm that the security indicator light
comes on. The security indicator light stays
on for about 30 seconds. The vehicle
security system is now pre-armed. After
about 30 seconds the vehicle security
system automatically shifts into the armed
phase. The security light begins to flash
once every approximately 3 seconds.
.
Opening the door without using the door
handle request switch, “UNLOCK”
ton on the Intelligent Key.
but-
.
Operating the hood.
How to stop alarm:
.
The alarm will stop only by unlocking a
door with the door handle request switch,
“UNLOCK”
Key.
button on the Intelligent
If, during this 30-second pre-arm time
period, the door is unlocked with the door
handle request switch, the “UNLOCK”
button on the Intelligent Key, the power
door lock switch, or the ignition switch is
pushed to the “ACC” or “ON” position, the
system will not arm.
.
The alarm will stop when the ignition
switch is pushed to the “ON” position.
If the system does not operate as described
above, have it checked by a NISSAN dealer.
NISSAN ANTI-THEFT SYSTEM (NATS)
The NISSAN Anti-Theft System (NATS) will not
allow the engine to start without the use of the
registered NATS key.
Even when the driver and/or passengers are
in the vehicle, the system will activate with all
doors locked and ignition switch in the
“LOCK” position. Push the ignition switch to
the “ACC” or “ON” position to turn the system
off.
3-16 Pre-driving checks and adjustments
English 
