Get Do-it-yourself -> Key fob battery replacement Guide for Nissan Qashqai SUV Third Generation (2021-2026)

KEY FOB BATTERY REPLACEMENT

NOTE:

If the extended storage fuse switch

malfunctions or if the fuse is open, it is

not necessary to replace the switch. In

this case, remove the extended storage

fuse switch and replace it with a new

fuse of the same rating.

CAUTION

Be careful not to allow children to

swallow the battery and removed

parts.

An improperly disposed battery

can harm the environment. Al-

ways confirm local regulations

for battery disposal.

When changing batteries, do not

let dust or oil get on the compo-

nents.

There is danger of explosion if the

lithium battery is incorrectly re-

placed. Replace only with the

same or equivalent type.

How to remove the extended storage

fuse switch:

1. To remove the extended storage fuse

switch, be sure the ignition switch is in

the OFF or LOCK position.

2. Be sure the headlights are off. (See

“Headlight switch” (P.2-52) or “Intelli-

gent Auto Headlight system” (P.2-52).)

JVM0415X

3. Remove the fuse box cover.

Extended storage fuse switch (if so

equipped)

4. Pinch the locking tabs

found on

each side of the extended storage

fuse switch.

To reduce battery drain, the extended

storage fuse switch comes from the

factory switched off. Prior to delivery of

your vehicle, the switch is pushed in

(switched on) and should always remain

on.

5. Pull the extended storage fuse switch

straight out from the fuse box

If the extended storage fuse switch is not

pushed in (switched on), the meter may

display a warning message. See “21. Ship-

ping Mode On Push Storage Fuse warn-

ing” (P.2-33).

If any electrical equipment does not

operate, remove the extended storage

fuse switch and check for an open fuse.

Do-it-yourself 8-21

CarManuals2.com

equivalent

authority to operate the equipment.

For Canada:

Do not touch the internal circuit

and electric terminals as doing so

could cause a malfunction.

This device contains licence-exempt

transmitter(s)/receiver(s) that comply

with Innovation, Science and Economic

Development Canada’s licence-exempt

RSS(s). Operation is subject to the fol-

lowing two conditions: (1) This device

may not cause interference. (2) This

device must accept any interference,

including interference that may cause

undesired operation of the device.

Hold the battery by the edges.

Holding the battery across the

contact points will seriously deplete

the storage capacity.

Make sure that the + side faces the

bottom of the case

3. Close the lid securely.

4. Operate the buttons to check its

operation.

If you need assistance for replacement, it

is recommended that you visit a NISSAN

dealer for this service.

FCC Notice:

For USA:

This device complies with Part 15 of the

FCC Rules. Operation is subject to the

following two conditions: (1) this device

may not cause harmful interference,

and (2) this device must accept any

interference received, including inter-

ference that may cause undesired op-

eration.

JVM0381X

KEY FOB (Type A)

To replace the battery:

1. Insert a small screwdriver into the slit

to open the lid. Use a cloth to

protect the casing.

2. Replace the battery with a new one.

Recommended battery: CR2032 or

8-22 Do-it-yourself

NOTE:

Changes or modifications not expressly

approved by the party responsible for

compliance could void the user’s

CarManuals2.com

lower part. Use a cloth to protect the

casing.

3. Replace the battery with a new one.

Recommended battery:

eration.

NOTE:

Changes or modifications not expressly

approved by the party responsible for

compliance could void the user’s

authority to operate the equipment.

CR1620 or equivalent

Do not touch the internal circuit

For Canada:

and electric terminals as doing so

could cause a malfunction.

This device contains licence-exempt

transmitter(s)/receiver(s) that comply

with Innovation, Science and Economic

Development Canada’s licence-exempt

RSS(s). Operation is subject to the fol-

lowing two conditions: (1) This device

may not cause interference. (2) This

device must accept any interference,

including interference that may cause

undesired operation of the device.

Hold the battery by the edges.

Holding the battery across the

contact points will seriously deplete

the storage capacity.

Make sure that the + side faces the

bottom of the case

4. Close the lid securely and install the

screw.

5. Operate the buttons to check its

operation.

If you need assistance for replacement, it

is recommended that you visit a NISSAN

dealer for this service.

FCC Notice:

For USA:

SDI2134A

KEY FOB (Type B)

This device complies with Part 15 of the

FCC Rules. Operation is subject to the

following two conditions: (1) this device

may not cause harmful interference,

and (2) this device must accept any

interference received, including inter-

ference that may cause undesired op-

Replace the battery in the key fob as

follows:

1. Remove the screw

2. Insert a small screwdriver into the slit

of the corner and twist it to

separate the upper part from the

Do-it-yourself 8-23

CarManuals2.com

Do-it-yourself -> Key fob battery replacement for Your Nissan Qashqai SUV Third Generation (2021-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals